Epson ES-800C Benutzerhandbuch - Seite 2
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Software Epson ES-800C herunter. Epson ES-800C 5 Seiten. Product support bulletin(s)
Auch für Epson ES-800C: Ergänzendes Handbuch (15 seiten), Handbuch (11 seiten), Produkt-Support-Bulletin (5 seiten), Produkt-Support-Bulletin (8 seiten)
Seite drucken
ES-800C
Width:
Dimensions and
weight:
Depth:
Height: 161 mm (6.5 inches)
Weight: about 12 kg (26 lbs)
Electrical Specifications
120 VAC, flO%
Voltage:
Frequency:
49.5
to
Power
Approx. 50 W (max)
consumption:
Insulation
20 m between AC power line and
resistance:
chassis at 500 VDC
Environmental Conditions
Temperature:
Operation: 40" F to 95" F (5" C to 35" C)
Storage: 10' F to 150" F (-20" C to 60" C)
Humidity:
Operation: 30% to SO%, without
condensation
Storage: 20% to 85%, without
condensation
Operating
Ordinary office or home conditions.
conditions:
Extreme dust should be avoided.
Operation under direct sunlight
or near a strong light source should be
avoided.
Note:
subject to change without notice.
are
Parallel Interface Specifications
Bidirectional parallel interface
Interface type:
Data format:
S-bit parallel
Synchronization:
By external strobe pulse
Handshaking:
By ACKNLG and BUSY signals
Logic level:
Input/output data and interface control
signals are TTL level compatible
Connector type:
36-pin Centronics@ type connector
Connector pin
arrangement:
18
36
ES-800C-2
368 mm (14.5 inches)
577 mm (22.5 inches)
60.5
Hz
SCSI Specifications
Interface type:
Function:
Logic level:
Electrical standard: As per ANSI X3.131-1986
ID Setting:
Connector type:
Scanning Functions
Scanner settings
The table below summarizes the scanner functions and the
settings available on your scanner. All of these functions are
controlled by the software commands from your scanner
software.
Function
Resolution
Size
Gamma correction
Color correction
11/2/92
ANSI X3.131-1986 standard
The following functions are included.
BUS FREE phase
ARBITRATION phase
SELECTION/ RESELECTION phase
COMMAND phase
(Logical Unit number is fixed to 0 and
command link function is not supported.)
DATA phase
Data in phase
Data out phase
STATUS phase
MESSAGE phase
(Includes MESSAGE IN phase and
MESSAGE OUT phase)
ATTENTION condition
RESET condition
TTL level compatible
Selectable from 0 to 7 with the rotary
switch.
(8 and 9 should not be selected.)
Two 50-pin connectors
Available settings
23 settings from 50 to 800 dpi
50% to 200% at 1% step
Color line sequence mode, color page sequence
mode and monochrome mode (dropout color
4 dither patterns
5 settings for output devices
4 settings for output devices
Scanners