2. Hold down the
Pause
Pause light begins flashing and the printer enters Micro
Adjust mode.
D to feed paper backward, or
3. Press
LF/FF
feed paper forward, until the paper perforation is aligned
with the tear-off edge of the printer cover.
The printer has a minimum and a maximum tear-off
position. If you try to adjust the tear-off position beyond
these limits, the printer beeps and stops moving the
paper.
4. Tear off the printed pages.
5. Press the
button to turn off Micro Adjust mode.
Pause
When you resume printing, the printer automatically feeds the
paper back to the top-of-form position and begins printing.
Adjusting the top-of-form position
The top-of-form position is the position on the page where the
printer starts printing. If your printing appears too high or low
on the page, you can use the Micro Adjust function to adjust
the top-of-form position, as described below. Your top-of-form
position setting remains in effect until you change it, even if you
turn off the printer.
Never use the knob to adjust the top-of-form position;
this may damage the printer or cause it to lose the
top-of-form position.
1. Make sure the printer is turned on.
2. Load paper. (If the tractor is in a push position, press the
button to advance continuous paper to the
Load/Eject
current top-of-form position.) If necessary, lift up the
printer cover so you can see the paper position.
3. Hold down the
Pause
light flashes and the printer enters Micro Adjust mode.
button for about three seconds. The
Load/Eject
tear-off edge
paper
perforation
button for three seconds. The Pause
4. Press the
LF/FF
up on the page, or press the
the top-of-form position down on the page.
U to
5. Press the
Pause
The printer has a minimum and a maximum top-of-form
position. If you try to adjust it beyond these limits, the
printer beeps and stops moving the paper.
When the paper reaches the default top-of-form
position, the printer beeps and stops moving the paper
briefly. You can use this setting as a reference point
when adjusting the position.
The top margin setting made in some software
overrides the top-of-form position setting you make
with the Micro Adjust function.
Loading Special Papers
Follow the guidelines in this section when loading continuous
multipart forms, single-sheet multipart forms, labels, and
envelopes.
Continuous multipart forms
Except for setting the paper-thickness lever, you load
continuous multipart forms the same way as ordinary
continuous paper. Just keep the following in mind:
Be sure your multipart forms do not exceed 0.018 inch
(0.46 mm) in thickness.
Do not load paper that is curled or has been folded.
Thick paper, such as multipart forms with five or six parts,
requires a straight paper path to avoid paper jams. Load
thick paper in the front or bottom slots.
10/01
EPSON FX-880+/FX-1180+
D button to move the top-of-form position
U button to move
Load/Eject
button to exit Micro Adjust mode.
EPSON FX-880+/FX-1180+
11
-
Seite drucken