Toshiba Carrier MMD-AP0094SPH2UL Installationshandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Installationshandbuch für Klimagerät Toshiba Carrier MMD-AP0094SPH2UL herunter. Toshiba Carrier MMD-AP0094SPH2UL 44 Seiten. Air conditioner multi type

Seite drucken

Installation of the indoor unit

All issues related to locating the unit above the ceiling,

hanging the unit from the building structure, routing/

suspending the unit refrigerant piping, routing/

suspending the unit wiring and penetrating the ceiling

for supply and return air connections to the indoor unit

must comply with all applicable codes and regulations.

The indoor unit should be hung above

the ceiling utilizing minimum 3/8" x 16

bolts, or threaded rod (4 pieces required) along with 3/

8" x 16 nuts, 3/8" flat washers and 3/8" lock washers.

All material locally procured.

Hanging bolt

W3/8" (M10)

4 pieces

Nut

W3/8" (M10)

12 pieces

Hanging bolt

M10 flat washer

(W3/8" (M10))

(Accessory)

Nut

(W3/8" (M10))

M10 flat washer

(Accessory)

Nut

(W3/8" (M10))

The unit should be positioned level and plumb without

pitch in any direction. The bolts, or threaded rod should

be attached to the building structure in compliance with

all applicable codes and regulations. The spacing for

the support bolts, or rods should match the dimensions

provided on the unit External dimensions in this

manual.

• Check that four sides are horizontal with a level

gauge. (Horizontal degree: Within 0.2" (5 mm))

11-EN

REQUIREMENT

• Hang the unit in a horizontal position.

When unit is hanged to slant, it may cause overflow of

drainage.

• Install the unit within the dimension according to the

figure below.

• Use level gauge to confirm whether the unit is hang

horizontally.

Side view

Set the drain pipe connecting port side within

0.2" (5 mm) lower than opposite side.

Front view

Set the air intake and air discharge sides are

within 0.2" (5 mm) with each other.

Installation of wired remote

control (sold separately)

For installation of the wired remote control refer to the

instructions that are supplied with the control. The

connection point for the control wiring and the entrance

point for the control wiring are clearly marked in the

instructions.

Installation of wireless

remote control

(sold separately)

For installation of the wireless remote control refer to

the instructions that are supplied with the control. The

connection point for the control wiring and the entrance

point for the control wiring are clearly marked in the

instructions.

The sensor of indoor unit with wireless remote control

can receive a signal by distance within approx. 26.2' (8

m).

Based upon it, determine a place where the remote

control is operated and the installation place.

• Keep 3.3' (1 m) or more from the devices such as

television, stereo.

(Disturbance of image or noise may generate.)

• To prevent a malfunction, select a place where is not

influenced by a fluorescent light or direct sunlight.

• Two or more (Up to 6 units) indoor units with wireless

type remote control can be installed in the same

room.

– 6 –

12-EN