Epson Stylus Pro - Stylus Color Pro Ink Jet Printer Spezifikationsblatt - Seite 5
Blättern Sie online oder laden Sie pdf Spezifikationsblatt für Software Epson Stylus Pro - Stylus Color Pro Ink Jet Printer herunter. Epson Stylus Pro - Stylus Color Pro Ink Jet Printer 15 Seiten. Macintosh & macintosh power pc version 3.1 for stylus color/pro/pro xl
Auch für Epson Stylus Pro - Stylus Color Pro Ink Jet Printer: Spezifikationsblatt (1 seiten), Installations- und Betriebshandbuch (44 seiten)
Seite drucken
Word format:
Data bit
8 bits
Parity bit
None
Start bit
1 bit
Stop bit
1 bit
Connector:
8-pin mini-circular connector
Recommended
Apple System/Peripheral-8 (part
cable:
number M0197) or equivalent
Optional Interfaces
Please refer to the specifications in the user's guide packed
with the optional interface card.
Initialization
The printer can be initialized (returned to a fixed set of
conditions) in these ways:
Hardware
The printer is turned on.
initialization
The printer receives an
parallel interface: pin 31 goes LOW.
Software
Software sends the ESC @ (initialize the printer)
initialization
command. The last panel settings are kept.
Control panel
Hold down the Alt button and press the Pause
initialization
button (buffer clear). The last panel settings are
kept.
All three initialization methods reset the font according to
the default settings selected using the control panel.
However, ESC @ does not initialize the printer mechanism,
clear the input data buffer, or clear the user-defined character
set. The control panel initialization does not initialize the
printer mechanism or clear the user-defined character set.
Default Settings
The table below shows the default settings that take effect
when the printer is initialized.
Item
Default setting
Top-of-form position
Current paper position
Page length
Single sheets:
61 lines for letter-size paper
65 lines for A4-size paper
Left and right margins
Cancelled
1
Line spacing
-inch line spacing
6
Character pitch
Last font selected on control panel
Vertical tab position
Cleared
Horizontal tab
Every eight characters
positions
Font selection
Last font selected on control panel
Ink Jet Printers
INIT
signal from the
8/1/95
EPSON Stylus Pro and Pro XL
Item
Default setting
Special printing effects Cancelled (except condensed and economy
printing)
User-defined
Hardware/control panel initialization: cleared
character set
Software initialization: deselected only
Graphic mode
ESC K = ESC
assignment
ESC Y = ESC
In addition, hardware and control panel initialization erases
any text in the data buffer.
Control Panel
The printer's front control panel contains lights for
displaying the printer status and buttons for controlling
certain settings.
Operate
button
Since most printer settings can be controlled from software,
you do not often need to use the control panel. This section
describes how to read the lights and the buttons on the
control panel.
Lights
On when the printer is on. Flashes when the
Operate
printer is turned on or off.
Data
On when data is being received by the printer
or when data remains in printer memory.
On when the printer runs out of paper. Rapid
Paper Out
flashing indicates a paper jam.
On when one or both ink cartridges are not
No Ink
Cartridge
installed. The printer will not work unless
both cartridges are installed.
Font
Indicates the font selected through the control
panel. Because you normally choose fonts
from your software, ignore this light.
On when economy printing mode is selected.
Economy
In economy mode the printer uses less ink by
printing fewer dots per character. Use this
mode for rough drafts of text only.
EPSON Stylus Pro and Pro XL-5
0, ESC L = ESC
1,
2, ESC Z = ESC
3