Epson Stylus Pro 9880 ColorBurst Edition - Stylus Pro 9880 ColorBurst Netzwerk-Handbuch - Seite 42

Blättern Sie online oder laden Sie pdf Netzwerk-Handbuch für Software Epson Stylus Pro 9880 ColorBurst Edition - Stylus Pro 9880 ColorBurst herunter. Epson Stylus Pro 9880 ColorBurst Edition - Stylus Pro 9880 ColorBurst 46 Seiten. Warranty statement
Auch für Epson Stylus Pro 9880 ColorBurst Edition - Stylus Pro 9880 ColorBurst: Broschüre (1 seiten), Erste Schritte (13 seiten), Broschüre & Specs (8 seiten), Handbuch (12 seiten), Eingeschränkte Garantie (12 seiten), Anweisungen zum Auspacken und Einrichten (28 seiten)

Seite drucken

Epson Stylus Pro 9880 ColorBurst Edition - Stylus Pro 9880 ColorBurst Netzwerk-Handbuch

Checking the LAN

First, you need to check that the computer can reach to other computers in the same

segment, as follows:

1. Set the default gateway to the host on which you are setting up the network interface.

If there is a server or a router which acts as a gateway, enter the address of the server

or the router. If there is no gateway, enter the IP address of your computer as a gateway

address.

2. Assume that you want to reach to the computer having the IP address

"192.168.100.101". Check that the computer is reachable by "pinging" it from the

command line:

ping 192.168.100.101

3. If the computer is reachable, you can see the following result (the exact form of the

message depends on your operating system, and the time may vary):

64 bytes from 192:168:100:101:icmp_seq=0. Time=34.ms

4. If the computer is unreachable, you may see something like this:

PING 192:168:100:101:56 data bytes

If you press Ctrl-C, you may see something like this:

192:168:100:101 PING Statistics

3 packets transmitted, 0 packets received,

100% packet loss

Again, the exact wording of the message you see may differ from this, depending on

your operating system. If you cannot "ping" the computer, check the following:

❏ The address in the ping command is correct.

❏ The Ethernet connection to the computer has been made correctly, and all hubs,

routers, etc. are switched on.

Setting and checking the new IP address

To set the new IP address of the network interface which you have obtained from your

network administrator, use the ping command and arp command with the -s flag (create

an ARP entry).

Note:

In the following procedure, we assume that the MAC address of your network interface is

00:00:48:93:00:00 (hexadecimal), and that the IP address which you will be assigning is

192.168.100.201 (decimal). Substitute your values for these addresses when you type in the

commands.

Tips for Administrator