Philips AZ 2425 Benutzerhandbuch - Seite 18

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Stereo System Philips AZ 2425 herunter. Philips AZ 2425 50 Seiten. Cd radio cassette recorder
Auch für Philips AZ 2425: Spezifikationen (2 seiten), Spezifikationen (2 seiten)

Seite drucken

TROUBLESHOOTING

If a fault occurs, first check the points listed below before taking the set for repair.

If you are unable to remedy a problem by following these hints, consult your dealer or service

center.

WARNING: Under no circumstances should you try to repair the set yourself, as this would

invalidate the warranty.

PROBLEM

– POSSIBLE CAUSE

• REMEDY

No sound/power

– VOLUME is not adjusted.

• Adjust the VOLUME.

– Headphones are connected.

• Disconnect headphones.

– Batteries are exhausted.

• Insert fresh batteries.

– Batteries are incorrectly inserted.

• Insert the batteries correctly.

– Pwer cord is not securely connected.

• Connect the power cord properly.

– Batteries loaded but power cord still plugged

in and connected.

• Pull out the power cord from the MAINS

outlet and the set.

Reversed left and right sound/no sound

from one speaker

– Speakers incorrectly connected

• Connect properly: L to left, R to right

Poor bass sound

– Speakers not in phase.

• Connect speaker poles correctly, '+' pole (red

marked wire) to '+'; '–'pole (black/unmarked

wire) to '–'.

The type plate is located on the base of the set.

CD playback does not work

– CD is badly scratched or dirty.

• Replace or clean the CD, see Maintenance.

– Laser lens steamed up

• Wait until lens has acclimatized

The CD skips tracks

– CD is damaged or dirty.

• Replace or clean the CD.

– PROGRAM/SHUFFLE is active.

• Switch off the PROGRAM/SHUFFLE function.

Poor cassette sound quality

– Dust and dirt on the heads, capstan or

pressure roller.

• Clean the heads etc., see Maintenance.

– Use of incompatible cassette types (METAL

or CHROME).

• Only use NORMAL (IEC I) for recording.

Recording does not work

– Cassette tab(s) may be broken out.

• Apply a piece of adhesive tape over the

missing tab space.

Remote control does not function properly

– Batteries are exhausted.

• Insert new batteries.

– Batteries are incorrectly inserted.

• Insert batteries correctly.

– Distance or angle between the set is too

large.

• Reduce the distance or angle.