Toshiba TDP-MT500 Benutzerhandbuch - Seite 38
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Projektor Toshiba TDP-MT500 herunter. Toshiba TDP-MT500 42 Seiten. Home projector
Auch für Toshiba TDP-MT500: Benutzerhandbuch (40 seiten)
INDICATORS
How to see the internal states from indicators
There are three indicators that inform of the internal states of the projector. The internal states can be
known by how the indicators are lighting. Check the followings, and if there is any problem, stop to use
the projector and be sure to unplug the power plug. Then, contact a repair/customer front of Mitsubishi
Electric Corporation.
POWER indicator
When the projector is normal:
POWER LAMP TEMP STATE
On in orange
Blinking in green
Off
Off
On in green
Blinking in orange
If the projector is not normal:
POWER LAMP TEMP STATE
On in red
On in
Off
orange
Off
On in red
On in
green
Blinking
in red
Off
On in
orange
On in red
Kensington Lock
This projector has a Kensington Security Standard connector for use with a Kensington MicroSaver Security
System. Refer to the information that came with the Kensington System for instructions on how to use it to
secure the projector. Please contact to Kensington Technology Group as shown below.
Kensington Technology Group
2855 Campus Drive
San Mateo, CA 94403, U.S.A.
Phone : (650)572-2700
38
MENU/EXIT
POWER
Standby state.
Lamp standby state.
Power "ON" (usually).
Lamp is being cleaned.
The interior of the projector is very hot.
• The intake vent and/or exhaust vent is blocked
with something.
• The projector is used at a very hot place such as
outlet of heating air.
• The air filter is foul.
The protection circuit is working, or
The lamp is not normal.
(When power is turned off normally, this indication appears,
and this is not a failure.)
Indicating replacement of the lamp (Used about 1000
hours* in total; Power is "ON".)
Indicating replacement of the lamp (Used about 1000
hours* in total; Power is "OFF".)
Indicating replacement of the lamp (Used about 1500
hours* in total)
Fax : (650)572-9675
ENTER
LAMP
TEMP
TEMP(temperature) indicator
REMARK
Power can not be turned "OFF".
Power can not be turned "ON".
REMARK
Countermeasure
• Remove those things with which the
vent is blocked.
• Relocate the projector.
• Clean the filter.
• Press POWER button after POWER
indicator has ceased blinking.
If this operation is repeated several times and the
light-source lamp still does not come on, replace
the lamp to a new one. Ask the delivery agent of the
projector or a repair/customer front of Mitsubishi
Electric Corporation about purchase of the lamp.
Replace the light-source lamp to a new
one. Purchase a light-source lamp from
the delivery agent of the projector.
LAMP indicator