Croydex WC410222 Handbuch

Blättern Sie online oder laden Sie pdf Handbuch für Inneneinrichtung Croydex WC410222 herunter. Croydex WC410222 2 Seiten. White cabinets

White Cabinets

Thank you for purchasing this Croydex product. Please follow the fixing and care instructions to ensure

your cabinet is fitted safely and retains its high quality finish.

Please retain this leaflet for future reference.

This installation guide applies to the following cabinets:

WC410122 - Single Door White cabinet

WC410222 - Bi-View White Cabinet

Tools required - not supplied

Pencil;Tape Measure; Philips Screwdriver; Flat Head Screwdriver; Drill; 8mm Drill Bit (Ceramic drill bit op-

tional).

KEEP DIY TOOLS OUT OF THE REACH OF CHILDREN

Home Safety Advice

- It is recommended that two people fit this product to ensure that it is fitted safely.

- Always take care when using power tools, particularly in the bathroom.

- Always check for hidden cables and pipework before drilling and take extreme care if there is any

water in the working area.

- It is advisable to use a residual current circuit breaker (RCCB).

- Always wear suitable eye protection when drilling.

- If the product is to be fitted on a ceramic tiled wall, a ceramic drill bit should be used.

- Always ensure that the drill hole passes through the central tiled area rather than through the grouted

area. To prevent damage to the tile, mask the area around the hole with tape before drilling.

- Do not strike the product with hard or sharp objects.

Product Care

To retain the best quality finish, clean product regularly with a soft damp cloth.

Do not use abrasive or chemical cleaners as these will damage the product.

Do not overload the cabinet. Maximum safe working load is 10kg evenly distributed if mounted on to a solid

wall. If mounted on to a cavity wall reduce the load to 5kg evenly distributed.

A. Hang 'N' Lock Bracket x 1

E. Hang 'N' Lock Cam x 2

I. Wall Plugs x 4

B. Hang 'N' Lock Bracket x 1

F. Hang 'N' Lock Locking Stud x 2

J. Hang 'N' Lock hole cap x 2

C. Hang 'N' Lock Spacer x 1

G. Countersink Fixing Screws x 2

(Optional)

4 screws are supplied within this fixing pack.

Only 2 x screws are required to install the Hang 'N' Lock bracket.

Please use either the countersink or dome head fixing screws supplied.

K. Shelf Support x 4

D. Hang 'N' Lock Spacer (Small)

H. Fixing Screws x 2 (Optional)

CAB 086 R03