CRRC MS-ZD20 Gebrauchsanweisung - Seite 7

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Werkzeuge CRRC MS-ZD20 herunter. CRRC MS-ZD20 13 Seiten. Electric installation tool

3. Operation

a. Inspect the connection of moving parts.

b. Inspect the connection of pintail collector.

c. Inspect the battery.

STEP1: Thread the nut sleeve into front of cylinder until the end.

STEP2: Push the sensor to cylinder; thread the nut sleeve at anti-clockwise to

sensor; tighten 4 set screws from nut sleeve to sensor.

STEP3: Thread collect assembly into cylinder.

STEP4: Thread anvil socket into collect assembly.

STEP5: Insert jaw into anvil, then thread jaw into sensor and anvil socket.

STEP6: Install pintail collector to rear of cylinder.

STEP7: Install battery.

STEP8: Adjust the riveting force: Set the riveting force to 5 kN by the buttons

under the LCD display, and then lock down the force.

Lock

Notes of Reset/lamp switch:

a. the lamp can be turned on only when force is locked;

b. Depress the Reset/lamp switch for 3 to 5 seconds to reset the tool.

Reset/lamp switch

Down