CRU Data Express 50 Benutzerhandbuch - Seite 2

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Gehege CRU Data Express 50 herunter. CRU Data Express 50 2 Seiten. Sas/sata 6g removable enclosure

Seite drucken

1 Installation Steps

1.1 Frame Installation

a. Turn off power to the computer and open up the computer so that the Data

Express frame can be installed into a 3.5" or 5.25" bay in the front of the

computer.

NOTE: To install the Data Express 50 (DE50) into a 5.25" bay, attach the

Data Express frame to a DE50 5.25" adapter (may be sold separately) using

four (4) M3 Phillips Pan Head screws (included).

b. Insert the Data Express frame into an open 3.5" or 5.25" computer bay.

c. Fasten the Data Express frame into place using the appropriate screws

provided. Mounting holes are provided on the 5.25" adapter on each

side and the bottom of the adapter bracket to accommodate a variety of

mounting configurations in 5.25" bays.

d. Connect the SAS/SATA power cable from your computer to the rear of the

Data Express frame.

e. Connect a SAS or SATA data cable to your computer's motherboard or host

card. Then connect the other end to the rear of the Data Express frame.

1.2 Unit ID Number Selection

a. Make sure that the Data Express carrier is removed from the receiving

frame.

b. Turn the Data Express frame on by inserting the included Data Express

key into the key lock and turning the key 90 degrees counter-clockwise. A

'u' will be displayed on the Unit ID Number Indicator on the frame's LCD

display.

c. Insert the provided alignment tool into the Unit ID Select Switch Slot,

which is located just underneath the Unit ID Number Indicator. Rotate the

tool to set the desired number. The following table lists the available Unit

ID Select Switch settings.

Unit ID Select

Switch Position

Unit ID Number

Blank 0

Display

1.3 Drive Installation

a. Remove the four (4) M3 Phillips Flat Head screws from the sides of the Data

Express carrier and set them aside.

Blank Blank 2

Blank Blank Blank

b. Carefully remove the top cover and the drive carrier circuit board from the

bottom plate assembly.

Attach the SAS/SATA connector of the drive carrier circuit board to the

rear of a 2.5" SAS or SATA hard drive.

d. Turn the hard drive upside down and secure the bottom plate assembly to

the bottom of the drive using the four (4) M3 screws provided.

Turn the drive/bottom plate assembly right-side up and attach the top

cover to it using the four (4) screws you removed in Step 1.3.a.

2 Operating Your Data Express 50 Removable Enclosure

Insert the Data Express carrier into the Data Express frame. Push firmly

until the carrier slides into place.

b. Turn the Data Express removable enclosure on by inserting the included

Data Express key into the key lock and turning it 90 degress counter-

clockwise.

Your Data Express 50 removable enclosure is now ready to use! If the hard drive is

already formatted, it can be used right away. If the hard drive is brand new, or its

format is not compatible with your computer, the drive will need to be formatted

before being used.

CRU Mark

10.25.12

PMS 711

2 cyan

85 magenta

76 yellow