CRU Dataport DE200 SCSI Handbuch installieren

Blättern Sie online oder laden Sie pdf Handbuch installieren für Gehege CRU Dataport DE200 SCSI herunter. CRU Dataport DE200 SCSI 2 Seiten. Removable scsi wide ultra320 drive enclosure for de200 ultra320 68-pin

Seite drucken

CRU Dataport DE200 SCSI Handbuch installieren

DE200 Ultra320 68-Pin Install Guide

Removable SCSI Wide Ultra320 Drive Enclosure

Notes: For SCSI Ultra320 operation, the DE200 Ultra320 requires

Ultra320 drives, Ultra320 HBA, and Ultra320-compliant cabling

(internal and external).

DE200 Ultra320 can support Ultra320 implementations with a

maximum of fifteen (15) Ultra320 drives (Ultra320 repeater may be

required).

DE200 Ultra320 receiving frames are indicated by their BLUE LED,

while the DE200 Ultra320 carriers are indicated by the Ultra320 logo.

Figure 1: Drive Installation Assembly

Installation

1. Locate the ID select jumper positions on the drive, and remove any

jumper plugs installed (the drive carrier board will plug into this sec-

tion of the drive).

2. Carefully insert the drive into the carrier. Slide the drive towards the

drive carrier board, so that the I/O, DC power, and ID select connec-

tors on the drive mate with their respective connectors on the drive

carrier board.

3. Fasten the drive into place with four (4) #6-32 Phillips Flat Hd.

screws (provided).

Rugged, Reliable, Mobile, Secure

Receiving Frame Motherboard

Remote Unit ID Selection: Pins 1-8 are provided for remote unit ID

selection for the computer system or expansion chassis. Remote ID

selection requires that the unit ID switch located on the inside of the

receiving frame be set to "0" (onboard ID selection is set with a switch

located on the inside of the receiving frame; see figure 3).

Enable Termination Power Connector (J4): This jumper is installed at the

factory and enables termination power to/from the SCSI bus.

NOTE: Do not remove this jumper!

Figure 2: Receiving Frame Motherboard (rear view)

1-800-260-9800