CRU Dataport LP Handbuch installieren

Blättern Sie online oder laden Sie pdf Handbuch installieren für Lagerung CRU Dataport LP herunter. CRU Dataport LP 2 Seiten.

DataPort LP Install Guide

The DataPort LP is designed to mount via top, bottom, or

side mounts. This allows the maximum number of options to

mount the DataPort LP into any enclosure.

Package Contents

1 - DataPort LP Carrier

1 - DataPort LP Frame

4 - 6 x 32 x 3/8" flat-head screws for hard drive mounting

4 - M3 x 10mm Phillips pan-head screws for frame mounting

Installation

To install the DataPort LP, remove the carrier from the

frame. To remove the carrier, press the release button on

the left corner of the carrier. This will release the ejection

lever to remove the carrier (see figure 1). Extend the ejec-

tion lever fully to release the carrier. Use the lever to pull

the carrier out of the frame.

release

button

Figure 1: Front View

Rugged, Reliable, Mobile, Secure

Install the Frame Into the Enclosure

1. Slide the frame into the enclosure and, using the screw

holes provided, secure the frame into the enclosure. For

installations requiring mounting rails, attach the mount-

ing rails and then slide the frame into the enclosure.

2. Connect the data cable and the power cable to the back

of the frame.

Install the Hard Disk Drive Into the Carrier

1. Set the Master/Slave jumpers on IDE drives, before

installing the hard drive into the carrier.

2. On the IDE version, connect the power cable and the

IDE data cable to the hard drive. For SATA hard drives

connect the hard drive to the data and power connector.

Then secure the drive to the carrier via either the side or

bottom mount holes with the provided screws.

Make sure the lever is fully extended before inserting the

carrier into the frame. Insert the carrier and then close the

lever by pushing it back in to complete the insertion and

secure the carrier. Power up the enclosure; the drive should

spin up and be operational. The green LED indicates that

the drive is powered up and the amber LED indicates drive

activity.

1-800-260-9800