CRU Dataport SATA DE110 Handbuch installieren

Blättern Sie online oder laden Sie pdf Handbuch installieren für Computer-Zubehör CRU Dataport SATA DE110 herunter. CRU Dataport SATA DE110 2 Seiten. Sata de110 install guide removable sata 1.5gb/s drive enclosure

Seite drucken

DataPort

™

SATA DE110 Install Guide

Removable SATA 1.5Gb/s Drive Enclosure

NOTE: For SATA 1.5Gb/s operation, a SATA controller and

appropriate SATA cable are required.

Drive Carrier

JP1

Provides a signal to the Activity Indicator when connected via cable

(provided) to the SATA drive. Some SATA drives/host controllers pro-

vide support for the Activity Indicator feature (refer to the SATA drive/

host controller manufacturer's documentation for further information).

Serial ATA

Logo

Key Lock/Drive

Power Switch

"Universal" Receiving Frame Motherboard

Factory-Installed Jumper (ID0 & ID1)

Factory-installed jumper. Refer to Figures 2 & 4 for further information.

Remote Activity LED (RLED)

These pins provide a remote LED device activity indicator (Pin 13 =

Cathode, Pin 14 = Anode).

Factory Reserved Pins

These pins are reserved for factory use only - Do not install jumper

under any circumstances!

Activity Indicator

Pin 13 is used for host connection (cable not included) to the Activ-

ity Indicator. Some SATA drives/host controllers provide support for

the Activity Indicator feature (refer to the SATA drive/host controller

manufacturer's documentation for further information).

Installation

1. Carefully insert the drive into the carrier. Slide the drive towards

the Drive Carrier Board, so that the I/O connector on the drive

mates with the connector on the Drive Carrier Board. Turn the

drive/carrier assembly over.

JP1

Red Cable

Black Cable

(connect to

drive activity on

drive)

Figure 1: Drive Carrier

Rugged, Reliable, Mobile, Secure

DC Power

Connector (P1)

Activity

Indicator

(Pin 13)

Reserved

(Pin 14)

Factory Reserved Pins

(J2 - no jumper installed)

2. Fasten the drive into place with four (4) #6-32 Phillips Flat Hd.

screws. Some drives may require minor adjustment before

securing into carrier with screws. If drive supports the Activity

Indicator feature, connect one end of the Activity Indicator Cable

(provided) to the drive and the other end to JP1 located on Drive

Carrier Board (Figure 1).

NOTE: Some SATA drives/host controllers provide support for the

Activity Indicator feature (refer to the SATA drive/host controller

manufacturer's documentation for further information). There are two

ways to utilize the Activity Indicator:

a. Drive connection (cable included) to JP1 located on Drive

Carrier Board (Figure 1).

b. Host connection (cable not included) to J2 Pin 13 located on

Receiving Frame Motherboard (Figure 2).

3. Install the provided drive cover.

Spacer Plates (optional)

The SATA DE110 is designed to ﬁt most computer systems with

standard 5.25" peripheral slots. The installation of the spacer plates

(provided) may or may not be necessary.

NOTE: Depending on the computer system, spacer plates may be

positioned on the receiving frame to utilize either top or bottom row

of side-mounting holes.

1-800-260-9800

Option Pin

Connector (W1)

Factory

I/O Connector

Installed

(JP1)

Jumper

Figure 2: Receiving Frame

Motherboard (Rear View)

www.CRU-DataPort.com

Factory Installed

Jumper