Aeon 1702 Gebrauchsanweisung - Seite 2

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Racks & Ständer Aeon 1702 herunter. Aeon 1702 2 Seiten. Premium speaker stand

Seite drucken

Premium Speaker Stand

Instruction Manual

AEON-1702 - Page 2

INSTALLATION STEPS

1) Remove all components from carton and unwrap the protective bags.

2) See page one of this manual for a parts list of all parts included in the carton.

Familiarize yourself with each part and their corresponding letter. Use Figure A on

page one as a guide for the overall completed assembly.

3) Place a rubber pad on each of the three feet of the Stand Base (A) as shown in

Figure D.

4) Thread the Lower Bar Washer (D) onto the Lower Bar (C) as shown in Figure C

on to each Lower Bar.

5) Attach the Lower Bar (C) to the Stand Base (A) by inserting the Lower Bar into the

hole on the Stand Base and turning clockwise.

6) Turn the Lower Bar Washer (D) counter clockwise until it is tight onto the Stand

Base (A). The washer should be finger tight, and a pair of pliers should not be used.

7) Attach another Lower Bar Washer (D) to the underside of the Stand Base (A) and

finger tighten until it will not move. See figure E.

8) Insert the Upper Bar (B) into the Lower Bar (C) through the bar connector. When

you have inserted the Upper Bar to a desired height, twist the bar connector

clockwise until it is tight. The Upper Bar should not move up or down after the bar

connector is tightened. See Figure F.

9) Place the speaker stand assembly near the desired location that you want. Slide

your speaker wire into the hole under the Stand Base (A) through the Lower Bar (C)

and push the speaker wire until it appears at the top of the Upper Bar. Grab the wire

with your hands and pull until you have a few feet of speaker wire hanging out of the

top.

10) Match the holes on the back of your speaker with the Top Base Assembly (see

Figure B) and press into place. Press firmly to ensure a good fit.

11) Finish the completed assembly by hooking up your speaker with the speaker

wire. Your finished assembly should look like Figure A on page one.

NOTES

The height of the Upper Bar is adjustable. Simply loosen the Bar Connector on the

Lower Bar by turning it counter clockwise. This will free the Upper Bar to move up

and down. Set to the desired height and tighten the Bar Connector again by turning

it clockwise by hand. Be careful not to over tighten the Bar Connector of you may

damage the stand.

If you are using this speaker stand for an SLS Q-Line style speaker, please note that

there are four different positions that you can mount your speaker to the stand.

Each position has a pair of slots on the back of the speaker for easy placement.

WARNING

Be careful not over tighten the Upper and Lower Bar Connector. The connector

should only be slightly tight on the bar to prevent the Upper Bar from sliding. If

you over tighten the connector, or use a tool to tighten, you could break the

connector.

Figure B:

Top Base

Assembly

Figure C:

Attach Washer

to Lower Bar

Figure D:

Rubber Pad

Placement

Figure E:

Bottom Washer

Placement

Figure F:

Upper and Lower

Bar Connector

Do not over tighten