3Com 3C892 - OfficeConnect ISDN Lan Modem Router Einrichten - Seite 2

Blättern Sie online oder laden Sie pdf Einrichten für Modem 3Com 3C892 - OfficeConnect ISDN Lan Modem Router herunter. 3Com 3C892 - OfficeConnect ISDN Lan Modem Router 14 Seiten. Setting up the isdn lan modem on a static network
Auch für 3Com 3C892 - OfficeConnect ISDN Lan Modem Router: Handbuch "Erste Schritte (8 seiten)

Seite drucken

ISDN LAN M

ETTING

P THE

Setting Up TCP/IP for

Windows and

Macintosh

TCP/IP Setup Using

Windows 95

A S

ODEM

TATIC

ETWORK

labeled Phone and then connect the other end of the RJ-11 connector into

the appropriate RJ-11 port on the analog device.

Connect the power cable from the wall power module into the back panel

of the ISDN LAN modem and then plug the other end into a

110 VAC outlet. Use of a surge-protected outlet strip is recommended.

The Power LED illuminates. The indicator LEDs on the front panel ﬂash

momentarily as the unit undergoes a power-up self-test diagnostic. The ISDN

LED ﬂashes.

Turn on your computer which is connected to the ISDN LAN modem.

Once your computer is started, the LAN Status LED will ﬂash and then

illuminate green, indicating that the port to which your computer is

connected is ready for use and that proper communication between your

computer and the ISDN LAN modem has been established.

This completes the installation process. Refer to "Setting Up TCP/IP for

Windows and Macintosh" to continue.

This chapter describes how to setup the Windows and Macintosh operating

system (OS) TCP/IP stack. Your computer must have a TCP/IP stack in order to

use the ISDN LAN modem. If you already have TCP/IP installed and set up on

your computer, then go on to "Conﬁguring the ISDN LAN Modem". These

instructions vary depending upon which operating system you are using. Refer

to the appropriate section.

TCP/IP Setup Using Windows 95

TCP/IP Setup Using Windows NT 4.0

TCP/IP Setup Using Mac OS 7.6 or later

TCP/IP Setup Using Windows 3.11

Windows 95 provides TCP/IP as part of its standard operating system. To set up

TCP/IP for the ISDN LAN modem, do the following.

You may be prompted for your Windows 95 installation disks or CD-ROM.

1 From the Control Panel, double click Network .

The Network dialog box appears.

2 Click Add .

The Select Network Component Type dialog box appears.

Figure 1 Select Network Component Type Dialog Box