Dimplex contempra ef KDS6401E Teile- und Servicehandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Teile- und Servicehandbuch für Herd Dimplex contempra ef KDS6401E herunter. Dimplex contempra ef KDS6401E 19 Seiten. Dimplex - the glen dimplex group stove user's guide
Auch für Dimplex contempra ef KDS6401E: Praktisches Benutzerhandbuch (10 seiten), Teile- und Servicehandbuch (16 seiten)

Seite drucken
Dimplex contempra ef KDS6401E Teile- und Servicehandbuch
KDS6401E

OPERATION

To access the controls go to the front panel of the unit (refer to diagram below)
1. Three position ON/OFF switch
The switch has two ON positions marked with "-" and "=". The "-" position is for manual
operation. In this position the built-in remote control is bypassed. The "=" position is for
operating the unit with the provided remote control. When in "=" position the unit is operated
with the ON and OFF buttons of the remote control. When the switch is in the center position
the unit is off.
2. HEATER ON/OFF SWITCH
The HEATER ON/OFF SWITCH supplies power to the heater fan and the heater element
and must be turned on before heat can be created.
3. HEATER THERMOSTAT CONTROL
To adjust the temperature to your individual requirements, turn the heater thermostat control
knob clockwise all the way to turn on the heater. When the room reached the desired
temperature, turn the thermostat knob counter clockwise until you hear a click. Leave in this
position to maintain the room temperature at this setting. For additional heat, turn clockwise
until you hear the click again and the heater will turn on. To turn the heater off, switch the
HEATER ON/OFF SWITCH to the OFF position.
NOTE: When the heater is switched ON, the heater fan will operate. The heater element may
or may not be on, depending on the thermostat control setting (SEE "HEATER THERMOSTAT
CONTROL").
RESETTING THE TEMPERATURE CUTOFF SWITCH
This unit is equipped with a thermostat that controls the temperature of the room. It
does this by turning the heater on and off. The heater is protected with a safety device
to prevent overheating. Should the heater overheat, an automatic cut out will turn the
heater off and it will not come back on without being reset. To reset the temperature
cut-off switch turn the main power switch to the OFF position and wait five minutes
before switching the unit back on.
CAUTION
If you need to continuously reset the heater, unplug the unit and call Dimplex North
America Limited at 1-800-668-6663.
2