Dimplex Delaware DWR20 Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Herd Dimplex Delaware DWR20 herunter. Dimplex Delaware DWR20 8 Seiten. Opti-myst stove

Seite drucken

Dimplex Opti-myst Stove

Model: Delaware DWR20 (Contemporary Stove

IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE

Important Safety Advice:

When using electrical appliances, basic precautions should always be followed to reduce the

risk of fi re, electrical shock and injury to persons, including the following:

If the appliance is damaged, check with the supplier before installation and operation.

Do not use outdoors.

Do not use in the immediate surroundings of a bath, shower or swimming pool.

Do not locate the stove immediately below a fi xed socket outlet or connection box.

This appliance is not intended for use by children or other persons without assistance or

supervision if their physical, sensory or mental capabilities prevent them from using it

safely. Children should be supervised to ensure that they do not play with the appliance.

In order to avoid a hazard due to inadvertent resetting of the the thermal cutout, this

appliance must not be supplied through an external switching device, such as a timer, or

connected to a circuit that is regularly switched on and off by the utility.

Do not use this stove in series with a thermal control, a program controller, a timer or any

other device that switches on the heat automatically, since a fi re risk exists when the stove is

accidentally covered or displaced.

Ensure that furniture, curtains or other combustible material are positioned no closer than 1

metre from the stove.

In the event of a fault unplug the stove.

Unplug the stove when not required for long periods.

Although this stove complies with safety standards, we do not recommend its use on deep

pile carpets or on long hair type of rugs.

The appliance must be positioned so that the plug is accessible.

If the supply cord is damaged it must be replaced by the manufacturer or service agent or a

similarly qualifi ed person in order to avoid a hazard.

Keep the supply cord away from the front of the stove.

WARNING: In order to avoid overheating, do not cover the stove. Do not place material or

garments on the stove, or obstruct the air circulation around the stove.

The stove carries the Warning symbol indicating that it must not be covered

General.

Unpack the stove carefully and retain the packaging for possible future use, in the event of moving or

returning the stove to your supplier. The Remote Control and batteries are packed separately in the

carton.

The stove incorporates a fl ame eff ect, which can be used with or without heating, so that the

comforting eff ect may be enjoyed at any time of the year. Using the fl ame eff ect on its own only

requires little electricity.

These models are designed to be free standing and are normal positioned near a wall.

Before connecting the stove check that the supply voltage is the same as that stated on the stove.

Please note: Used in an environment where background noise is very low, it may be possible to hear

a sound which is related to the operation of the fl ame eff ect. This is normal and should not be a cause

for concern.

Electrical connection.

WARNING – THIS APPLIANCE MUST BE EARTHED.

This stove must be used on an AC ~ supply only and the voltage marked on the stove must correspond

to the supply voltage.

Before switching on, please read the safety warnings and operating instructions.

PLEASE RETAIN THIS USER'S GUIDE FOR FUTURE REFERENCE

Do not put Opti-myst plastic components into a dishwasher.

Only slide out the drawer when the water tank needs to be fi lled or a lamp needs to be changed

otherwise you will inadvertently alter the water level and the fl ame eff ect operation.

Only use fi ltered tap water in this appliance.

Always ensure that the stove is sitting on a level fl oor.

If you intend not using the appliance for longer than 2 weeks, drain the water from sump and

water tank and dry the sump.

Once installed, never move this stove or lay on its back, without draining the water from sump

and water tank.

The water tank, sump, sump lid, tank cap and air fi lters must be cleaned once every two weeks,

particularly in hard water areas.

The stove appliance should never be operated if the lamps are not working.

The lamps should be regularly inspected as described under 'Maintenance' and 'Changing

lamps'.

Installation Instructions

Ensure that all packing items are removed (read any warning labels carefully).

Retain all packing for possible future use, in the event of moving or returning the appliance to

your supplier.

To reduce heat losses and to prevent any chimney updraught aff ecting the operation of your

fi re we recommend that the chimney fl ue is blocked off , ensure that there is a slight gap for

ventilation.

To install the appliance;

Place the stove against the wall and connect the stove to your electricity supply.

Plug the stove into a 13amp/240volt outlet.

Before switching on the appliance, please read the following instructions.

Before using the manual controls fi rstly fi ll the water tank (See 'Maintenance' , 'Filling the water

tank').

)

Manual Controls .

The Opti-myst Manual controls are located in the drawer.

The main switch is located at the rear of the stove

(See Fig. 2 for Manual Control lay out)

Switch 'A':- Controls the electricity supply to the stove located at rear.

Note: This switch must be in the 'ON' ( I ) position for the stove to operate with or without heat.

Switch 'B':- Controls the function of the fi re.

Press

once to turn on fl ame eff ect. This will be indicated by one beep.

Although the main lights operate immediately it will take a further 30 seconds before the fl ame

eff ect starts.

Press

again to give fl ame eff ect and half heat. This will be indicated by two beeps.

Press

again to give fl ame eff ect and full heat. This will be indicated by three beeps.

Press

again to return to fl ame eff ect only.

This will be indicated by one beep.

Press

to put stove in to standby mode.

This will be indicated by one beep.

Control Knob 'C':- Controls the intensity of the fl ame eff ect.

Turning the control knob to the right increases the fl ame eff ect, turning the control knob to the left

will decrease the fl ame eff ect.

Control Knob 'D':- Controls the Electronic Thermostat setting.

Turning the control knob to the left will decrease the temperature setting, turning the control knob to

the right will increase the temperature setting.

When the water is empty the main lamps go out. See instructions under 'Maintenance' , 'Filling the

water tank' . When this procedure is complete, the main lamps will illuminate but it will take 30 seconds

before the fl ames return.

Depending on room temperature and humidity there may be some condensation on the inside of

the stove. This can be overcome by turning the fl ame control knob down and leaving the doors of the

stove slightly ajar, until the glass warms up.

Electronic Thermostat

The thermostat controls the heat output according to the room temperature. This ensures that

the stove will not produce heat unnecessarily when the room is warm.

To set the temperature you require, turn the thermostat control knob 'D' (See Fig. 2) to the right until

the desired temperature is reached. Alternatively to heat a cold room quickly, turn the thermostat

control knob 'D' (See Fig. 2) up fully. When the room has reached the desired temperature, turn the

thermostat control knob 'D' (See Fig. 2) to the left until the desired heat setting is achieved.

The stove will now automatically operate at this temperature.

Remote Control Operation

On the control panel, Switch A (see Fig. 2) must be in the 'ON' ( I ) position in order for the remote

control to operate. There are 3 buttons on the remote control. (See Fig. 7)

To operate correctly the remote must be pointed towards the front fuel eff ect.

The remote control functions are as follows:

Press once to turn on Flame eff ect only.

This will be indicated by one beep.

Press once to turn on Half heat and Flame eff ect.

This will be indicated by two beeps.

Press again to turn on Full heat and Flame eff ect.

This will be indicated by three beeps.

Standby

This will be indicated by one beep.

Battery Information.

Unclip the battery cover on the back of the remote control. (See Fig. 7)

Install AAA batteries into the remote control.

Replace the battery cover.

Discard leaky batteries.

Dispose of batteries in the proper manner according to provincial and local regulations.

Any battery may leak electrolyte if mixed with a diff erent battery type, if inserted incorrectly, if all the

batteries are not replaced at the same time, if disposed of in a fi re, or if an attempt is made to charge a

battery not intended to be recharged.

Thermal safety cut-out

A thermal safety cut-out is incorporated in the fan stove to prevent damage due to overheating. This

can happen if the heat outlet was restricted in any way or if the chimney fl ue has not been blocked off

eff ectively. If the cut-out operates, unplug the stove from the socket outlet and allow approximately 10

minutes before reconnecting. Before switching the stove back on remove any obstruction that may be

restricting the heat outlet, then continue normal operation.

Tips for using your appliance.

Only pull out the drawer when its time to refi ll the water tank or change a lamp, otherwise it may

lead to excess water in the sump and reduced fl ame eff ect. If this happens empty the water from

the sump as instructed under 'Maintenance' .

With the fl ame setting on minimum the unit will use approximately 40ml of water per hour and

will last 3 times as long than when it is at maximum fl ame setting.

Do not tilt or move the stove while there is water in the tank or sump.

Make sure that the stove is on a level fl oor.

The fl ame control knob 'C' Fig. 2 may be turned up or down to give a more realistic eff ect.

Sometimes the fl ames appear more real when the fl ame control knob is turned down.

Give the fl ame generator some time to react to changes you may make on the fl ame control

knob.

Maintenance

WARNING: ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE ATTEMPTING ANY

MAINTENANCE

- 1 -