Aeon Labs AEO MULTISENS Schnellstart-Handbuch - Seite 4

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Sicherheitssensoren Aeon Labs AEO MULTISENS herunter. Aeon Labs AEO MULTISENS 8 Seiten. Z-wave motion sensor, temperature sensor, humidity sensor and lightness sensor in one package

Seite drucken

A successful Inclusion/Exclusion lights up the sensor LED for a few seconds.

Operating the device

The Multisensor reports the temperature, humidity and lightness by request to a Z-Wave gateway or

controller. The sensor will send radio signals up to 6 associated Z-Wave devices within its own Z-Wave

network.

The sensitivity of the motion detector can be manually adjusted via the Sensitivity Knob at the battery cover.

To increase the sensitivity rotate the Knob clockwise, to decrease it rotate it counterclockwise.

Wakeup Intervals - how to communicate with the device?

This device is battery operated and turned into deep sleep state most of the time to save battery

life time. Communication with the device is limited. In order to communicate with the device, a static

controller C is needed in the network. This controller will maintain a mailbox for the battery operated devices

and store commands that can not be received during deep sleep state. Without such a controller,

communication may become impossible and/or the battery life time is significantly decreased.

This device will wakeup regularly and announce the wakeup state by sending out a so called Wakeup

Notification. The controller can then empty the mailbox. Therefore, the device needs to be configured with

the desired wakeup interval and the node ID of the controller. If the device was included by a static

controller this controller will usually perform all necessary configurations. The wakeup interval is a tradeoff

between maximal battery life time and the desired responses of the device.

A single click on the little button behind the battery will wake up the device and keep it awake.

It is possible to set the node ID to 255 to send wakeup notifications as broadcast. In this mode device takes more time to

go to sleep and drains battery faster, but can notify all it's direct neighbors about a wakeup.

Node Information Frame

The Node Information Frame is the business card of a Z-Wave device. It contains information

about the device type and the technical capabilities. The inclusion and exclusion of the device is confirmed

by sending out a Node Information Frame. Beside this it may be needed for certain network operations to

send out a Node Information Frame.

A single click on the little button behind the battery sends a Node Information Frame.

Associations