Pioneer DEH-200MP Benutzerhandbuch - Seite 14

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Auto-Empfänger Pioneer DEH-200MP herunter. Pioneer DEH-200MP 47 Seiten. Cd rds receiver

Seite drucken

Section

Connections

Important

! When this unit is installed in a vehicle without

ACC (accessory) position on the ignition

switch, red cable must be wired to the term-

inal that can detect the operation of the igni-

tion key. Otherwise, battery drain may result.

ACC position

! Use of this unit in conditions other than the

following could result in fire or malfunction.

— Vehicles with a 12-volt battery and negative

grounding.

— Speakers with 50 W (output value) and 4

ohm to 8 ohm (impedance value).

! To prevent a short-circuit, overheating or mal-

function, be sure to follow the directions

below.

— Disconnect the negative terminal of the

battery before installation.

— Secure the wiring with cable clamps or ad-

hesive tape. To protect the wiring, wrap ad-

hesive tape around them where they lie

against metal parts.

— Place all cables away from moving parts,

such as gear shift and seat rails.

— Place all cables away from hot places,

such as near the heater outlet.

— Do not pass the yellow cable through a

hole into the engine compartment to con-

nect to a battery.

— Cover any disconnected cable connectors

with insulating tape.

— Do not shorten any cables.

— Never cut the insulation of the power cable

of this unit in order to share the power

with other devices. Current capacity of the

cable is limited.

— Use a fuse of the rating prescribed.

— Never wire the speaker negative cable di-

rectly to ground.

— Never band together multiple speaker's ne-

gative cables.

! Control signal is output through blue/white

! Never connect blue/white cable to external

No ACC position

! Black cable is ground. This cable and other

cable when this unit is powered on. Connect it

to an external power amp's system remote

control or the vehicle's auto-antenna relay

control terminal (max. 300 mA 12 V DC). If the

vehicle is equipped with a glass antenna, con-

nect it to the antenna booster power supply

terminal.

power amp's power terminal. Also, never con-

nect it to the power terminal of the auto anten-

na. Otherwise, battery drain or malfunction

may result.

product's ground cable (especially, high-cur-

rent products such as power amp) must be

wired separately. Otherwise, fire or malfunc-

tion may result if they are accidentally de-

tached.