Pioneer S-L7-A Betriebsanleitung - Seite 48

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Auto-Empfänger Pioneer S-L7-A herunter. Pioneer S-L7-A 50 Seiten. Stereo cd receiver/stereo cassette deck/ speaker system

Seite drucken

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong

with this component, check the points below. Sometimes the trouble may lie in another component. Investigate

the other components and electrical appliances being used. If the trouble cannot be rectified even after exercising

the checks listed below, ask your nearest PIONEER authorized service station to carry out repair work.

Symptom

Likely Cause

Power does not turn on.

Display unit's cord is disconnected.

Connect display unit cord properly

{oe P 7).

Power turns off abruptly

| @ Cooling fan vent is blocked.

@ Install so that the fan is not blocked.

during operation.

@ The CD receiver has been set ontop | @

Do not install the CD receiver on top

of a soft cloth or long-pile rug, thus

of materials that may block the vents.

biocking the cooling vents.

Power plug is disconnected.

@ Connect the power plug correctly

Not all connection cables are con- | @

Refer to the section on connections

nected properly.

and make sure all connections are

correct and secure.

Input selector is-not set correctly.

Press the Display unit's FUNCTION

button and select the desired com-

ponent.

@ Unit is set to DEMO mode.

@ Tocancel the demo mode, press the

power switch on either of the CD re-

ceiver, display unit, or remote con-

trol unit while the demo mode is op-

erating.

Can't switch between

Cassette deck or MD recorder is cur- | @

Function selector cannot be operated

functions.

rently recording.

during recording.

Play doesn't start when

Disc has been inserted upside down. | @

Load discs with label side (printed

the play/pause button is

surface) upwards.

pressed.

Disc is dirty.

Clean the disc.

Disc has scratches.

Replace the disc.

Common

to all components

Can''t listen to broad-

@ Antenna isn't connected.

Connect the antenna properly.

casts, or sound is

@ Antenna direction or position is poor.

| @

Orient antenna to the proper direc-

distorted.

tion and position.

@ An electrical appliance (fluorescent | @

Discontinue use of the appliance pro-

lamp, hair dryer, etc.) is being used

ducing the noise, or move it farther

in the near vicinity.

away from the antenna.

@® The frequency interval is incorrectly | @ Adjust the tuning frequency interval

set.

correctly («= P. 49}.

Broadcast is in stereo,

Monaural

indicator is lit in the dis- | @

Use the MENU button to select "FM

but sound from speakers

play.

AUTO" (= P. 16}.

is monaural.

Cassette tray doesn't

Electric power cord has been discon- | @

Reconnect the power cord.

open.

nected during tape travel.

Can't record

e@ Erasure-prevention tabs are broken | @

Either replace the tape, or place cel-

out from the tape cassette.

lophane tape over the erasure-pre-

vention tabs (= P. 21).

Sound is muddy or

@ Heads are dirty.

@ Clean the heads (= P. 47}.

distorted. When recording

over a previously recorded

tape, the previous record-

ing can still be heard.

Playback sound is muddy

| @ The Dolby NR setting isnotthesame | @ Set the Dolby NR system to the same

or distorted; high

as that used during recording.

setting as that used during recording

frequency sounds are

(ex P. 18).

excessively emphasized.

<ARB7126> En

hen

haw