Pioneer A9 Betriebsanleitung - Seite 17

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Stereo-Empfänger Pioneer A9 herunter. Pioneer A9 28 Seiten. Non swithing amp
Auch für Pioneer A9: Betriebsanleitung (28 seiten), Service-Handbuch (13 seiten), Betriebsanleitung (16 seiten), Service-Handbuch (5 seiten)

Seite drucken

Using the tuner

Chapter 5:

Using the tuner

Listening to the radio

The following steps show you how to tune in to

FM and AM radio broadcasts.

Press TUNER then press BAND to select

the tuner band.

Tune to a station.

There are four ways to do this:

Automatic tuning – Press and hold TUNE

+/– for about a second. Searching

automatically stops at the next station.

Manual tuning – To change the frequency

one step at a time, press TUNE +/–.

High speed tuning – Press and hold

TUNE +/– continuously.

Direct access – Use the number buttons to

enter the frequency (For example, to tune

to 106.00 (FM), press 1, 0, 6, 0, 0).

If the TUNED or STEREO indicators don't light

when tuning to an FM station because the

signal is weak, press the MPX button to switch

the receiver into mono reception mode. This

should improve the sound quality and allow

you to enjoy the broadcast.

Saving station presets

This receiver can memorize up to 30 stations,

stored in three banks of 10 stations each.

Tune to a station you want to memorize

then press T.EDIT.

The display shows ST. MEMORY, then a

blinking memory class.

Note

1 If you make a mistake halfway through, press D.ACCESS twice to cancel the frequency and start over.

2 When saving an FM frequency, the MPX setting is also stored.

3 Station memories will be lost if the receiver is left disconnected from the AC power outlet for an extended period.

Press CLASS to select one of the three

classes then press ST +/– to select the station

preset you want.

Press ENTER to store the station.

Naming station presets

You can your station presets for easy recall.

Choose the preset you want to name.

See Listening to station presets below.

Press T.EDIT.

A cursor appears at the first character position.

Input the name you want then press

ENTER.

Names can be up to four characters long.

• Use the ST +/– buttons to select

characters, and ENTER to confirm. If no

character is input, a space is input.

Tip

• Once you have named a station preset, you

can press DISPLAY when listening to a

station to switch the display between the

name and the frequency.

Listening to station presets

You will need to have some presets stored to do

this. See Saving station presets above if you

haven't done this already.

Press TUNER to select the tuner.