Pioneer VSX-5400 Betriebsanleitung - Seite 42

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Stereo-Empfänger Pioneer VSX-5400 herunter. Pioneer VSX-5400 47 Seiten. Audio/video stereo receiver
Auch für Pioneer VSX-5400: Service-Handbuch (37 seiten)

Seite drucken

LEARNING FUNCTIONS

Leann (w)

(Q) rrawvonare

JRECAt.e «Leann

auoine @ @ AUX

(=<

semmin

oMmBCRy

Ga GO Go Cl ce

@ LEARN indicator

This indicator lights when the Learn function is operating.

LIT: Learning is possible.

OFF: Regular remote contro! functions can be performed.

NOTE:

ff the LEARN indicator flashes, it indicates that the program capacity

is exceeded

and that the last command

has not been properly

memorized. All previously programmed commands except the fast one

are retained in memory. And you can use the program keys as they are

if the last command is not essential.

@ TRANSMIT indicator

This indicator flashes when remote control signals are being sent.

LEARN selector switch

This can be set as follows:

LEARN:

This position is used for storing the codes of your remote contro! unit.

USE:

Set to this position after codes have been stored in the LEARN position.

{Set to this position when using memorized commands.)

SR RECALL:

Set to this position when transmitting Pioneer unified remote control

code signals (Marked on the remote control unit).

Set the TRANSMIT MODE switch to AUDIO or VIDEO. In the AUX

mode, only the receiver remote control code is transmitted.

[Operation example}

1. Set the LEARN switch of the programmable remote contro! unit to

the LEARN position and set the TRANSMIT mode selector switch

to the VIDEO position.

is possible with the TRANSMIT

mode

selector

switch in any position, but VIDEO is used as an exarnple.

2. Place the transmission sections of the programmable remote control

unit and the remote control of the VCR facing each other.

1 to 2 inches

* Place the two units on a table, separated by 2 to

50m {1 to 2

inches},

Memorization will not be possible 1 they are too close.

3. Hold down the VCR PLAY key of the Programmable remote controt

unit until the LEARN indicator light up, then release the key.

4. Hold down the PLAY key of the VCR remote control unit.

5. Release the key of the VCR remote control unit after making sure

that the LEARN indicator has gone out on the Pioneer remote control

unit.

NOTE:

if the LEARN indicator flashes, it indicates that you are trying to preset

a key not available for the learning function, or otherwise the program

capacity has been exceeded, the function programmed last will not be

memorized correctly. Ail previously pragrammed functions, however,

will be retained in memory and may be used as they are if the last

function

is not essential.

For re-programming

refer ta page

"Returning to the Initial Settings."

6. Set the LEARN selector switch of the programmable remote control

unit to the USE position.

* The previous code (Pioneer uniform remote control code or code

for other equipment) is erased and replaced by the new code.

7. Check that the program works.

* Try actual operation and make sure the unit works properly.

* if the VCR does not operate when pressing the key, change angle,

position and distance between the remote control units and repeat

the programming procedure.

* When programming, make sure that the function indications (for

example,

, ee , Mf) on the other remote control unit and the

programmable remote control unit are the same. This will facilitate

operation.