Pioneer VSX-604S Betriebsanleitung - Seite 17

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Stereo-Empfänger Pioneer VSX-604S herunter. Pioneer VSX-604S 34 Seiten.

Seite drucken

OPERATING THE TUNER

Press the POWER switch to the ON position.

Select TUNER with the input selector.

Be sure to turn the TAPE 2 MONITOR button OFF when

listening to AM or FM broadcasts.

Switch ON the SPEAKERS

button corresponding to the

speakers you wish to use.

FM auto stereo reception and monaural reception

Each time you press the MPX MODE button, the MONO

indicator in the display section lights or goes out.

- lf an FM stereo broadcast is received when the MONO

indicator is out, the STEREO indicator lights, and sound is

in stereo.

* {f an FM stereo broadcast is received when the MONO

indicator is lit, the sound will be monaural.

If there is

interference during stereo mode reception, switch to mono.

The sound will become monaural but interference will be

reduced.

TUNING INTO STATIONS

Turn the multi-jog, and the tuning frequency changes. (Switch

off when the GU! MODE button is on.)

Turning in a clockwise direction raises the frequency, while

turning in a counter-clockwise direction lowers the frequency.

HW... soooob of

ede

L__]

1. Use the FM/AM button to select either FM or AM.

Confirm that the JOG MODE indicator in the display shows

"FREQ".

If "ST" is displayed, press the SELECT button to switch to

"FREQ".

PRESET TUNING

Switch off when the GUI MODE button is on.

1. Tune into the desired station.

See the section "TUNING INTO STATIONS". In addition

to station frequencies, the MPX MODE (auto stereo mode

or Monaural mode) can also be preset (FM only).

2. Turn the multi-jog until you reach the frequency of a

desired station.

When a Station is received, the TUNED indicator will fight up.

NOTE:

The TUNED indicator may not light with broadcasts received over

long distances, or when the broadcast signals are extremely

weak.

3. Adjust the volume and tone as desired.

Auto tuning

Auto tuning is convenient when you do not remember the

frequency of a desired station, or when you wish to find

stations that you do not normally listen to. Operate by remote

control. (Refer to page 23.)

You can also perform Auto tuning GUI. (See page 25.)

2. Press the MEMORY button.

The station (channel) number flashes in the display.

(Memory mode)

3. Turn the multi-jog to select the station (channel]} you

want to memorize, and press the ENTER button.

* The station (channel) number lights in the display,

indicating that it has been memorized.

: If you do not press the ENTER button within about five

seconds after selecting a station, the memory mode is

canceled.

4. Repeat steps 1 to 3 to preset additional stations.

A total of 30 AM and FM stations may be preset. VWwhen

you store a new preset, it takes the place of the previously

stored station (if any).

You can also preset using GUI. (See page 25.)