Pioneer A9 Betriebsanleitung - Seite 7

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Verstärken Pioneer A9 herunter. Pioneer A9 28 Seiten. Non swithing amp
Auch für Pioneer A9: Betriebsanleitung (28 seiten), Service-Handbuch (13 seiten), Betriebsanleitung (16 seiten), Service-Handbuch (5 seiten)

Seite drucken

Before you start

Inserting the battery

Insert the lithium battery (CR2025) into the

remote control as shown below. The battery

supplied with this unit is stored in the battery

casing (see step 3 below). When you notice a

decrease in the operating range, replace the

battery in the same manner.

Push the release tab to the right to

open the battery casing.

Pull out the battery casing.

Remove the battery from the casing.

If you're doing this for the first time, remove the

protective seal from the battery supplied with

the system before re-inserting it.

Place a new battery in the casing.

Make sure the  side of the battery is facing up

when you place it in the space provided.

Caution

When using lithium batteries, please observe

the following:

• There is danger of explosion if the battery is

incorrectly replaced. Make sure to replace

only with the same or equivalent type

recommended by the manufacturer.

• Dispose of used battery cells immediately

after replacement. Keep away from

children.

• If swallowed, please contact a doctor

immediately.

Downloaded from

www.Manualslib.com

manuals search engine

• Lithium batteries may present a fire or

chemical burn hazard if misused. Do not

disassemble, heat above 100°C (212°F), or

incinerate.

• Remove the battery if the unit isn't going to

be used for a month or more.

• When disposing of used batteries, please

comply with governmental regulations or

environmental public instruction's rules

that apply in your country or area.

• Do not use or store batteries in direct

sunlight or other excessively hot place,

such as inside a car or near a heater. This

can cause batteries to leak, overheat,

explode or catch fire. It can also reduce the

life or performance of batteries.

Installing the receiver

• When installing this unit, make sure to put

it on a level and stable surface.

Don't install it on the following places:

– on a color TV (the screen may distort)

– near a cassette deck (or close to a device that

gives off a magnetic field). This may interfere

with the sound.

– in direct sunlight

– in damp or wet areas

– in extremely hot or cold areas

– in places where there is vibration or other

movement

– in places that are very dusty

– in places that have hot fumes or oils (such as

a kitchen)