Pioneer CX-J500 Betriebsanleitung - Seite 31

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Verstärken Pioneer CX-J500 herunter. Pioneer CX-J500 36 Seiten. Tuner control amplifier amplificateur de commande tuner / stereo power amplifier amplificateur de puissance stereo / sound image controller controleur d'image sonore / stereo double cassette tape deck double platine cassette stereo / auto-return stereo tu
Auch für Pioneer CX-J500: Service-Handbuch (26 seiten), Betriebsanleitung (35 seiten)

Seite drucken

TROUBLESHOOTING

to carry out repair work.

center oar your dealer

Symptom

Cause

Remedy

No power is supplied even when

power switch is ON {when the

control amplifier's power switch

is OFF, the entire system is OFF).

* Power plug is not connected to wall outlet.

* Connecting cables are not connected securely or

properly.

* Plug in the power plug securely,

* Refer to the connection section and make the

proper cable connections.

No sound from speakers.

* Cabies are disconnected from their connectors,

or connected improperly.

* Sound volume is set at MIN.

* Speaker cords are not connected.

* Speaker cords were connected without removing

the vinyl insulation,

* The amplifier's FUNCTION position is not set

properly for the source you wish to listen to.

* Disconnect the power piug from the wall outlet

and reconnect ail cables properly.

* Use the volume control to set the volume

appropriately.

* Connect the speaker cords properly.

* Strip the viny! insulation from the end of the

cords and reconnect them to the speaker cords.

* Set the FUNCTION properly.

Sound is heard from one side

only.

* One of the speaker's cords is disconnected or

cut.

* Connect the speaker cords securely to their

connectors, of replace with good cords.

CASSETTE DECK FUNCTIONS

The cassette deck's door does

not open.

« The deck is not in the stop mode.

¢ The unit's power was turned OFF while the tape

was sunning,

* Press the STOP button (mm).

* Turn on the power again.

The cassette deck's door does

not close.

* The tape cassette is not inserted properly.

* Insert the tape cassette properly,

nical:

The cassette tape does not run.

* The tape cassette is not inserted properly.

* Insert the tape cassette properly in the cassette

holder.

Tape sound can not be heard.

* The FUNCTION is not set to TAPE.

* A non-recorded tape has been loaded.

* Set FUNCTION to TAPE.

* Replace with a prerecorded tape.

Recording not possible.

* The cassette tape's erasure prevention tab is

broken.

* The cassette deck's connection with the tuner control

amplifier is disconnected or not connected properly.

* The amplifier's recording source selection is not

set properly.

* The deck's recording/playback heads are dirty.

* Exchange with a new tape, or cover the erasure

prevention tab holes with cellophane tape.

* Check all connections.

* Perform operations in accordance with the

procedures given in the section "Recording onto

A Cassette Tape."

* Clean the recording/playback heads.

When a new recording is made,

the previous recorded sounds

can still be heard on the tape.

-* Recording/playback heads are dirty.

* Clean the recording/playback heads.

Can not copy a tape.

* A cassette tape is loaded in only one of deck {

and deck li.

* The cassette tape loaded in deck il has its

erasure prevention tab broken.

* Cassette tapes must be loaded properly in both

decks.

* Replace with a tape whose erasure prevention

tab has not been broken.

Sound is muddy, or reduced in

volume.

* Recording/playback heads are dirty.

* A tape recorded without Dolby NR is being

played back with the Dolby NR switch B or C in

the ON position.

* Ciean the recording/playback heads.

* Set the Dolby NR switch to OFF.

High-frequency sounds are

overly emphasized.

* A tape recorded with Dolby NR type B or C is

being played back with the Dolby NR switch in

the OFF position.

* Set the Dolby NR switch to the B or C position

as appropriate.

{in the CT-J200WR, set to the ON position.}

Abnormal sounds (humming or

whistling) are heard when

listening to tapes, CD, or radio

broadcasts, and those sounds

are recorded on cassette tape

recordings.

* Your television's switch is ON when listening to

music.

* This unit is located too close to your television.

* You are trying to use high speed copying.

* Turn your television OFF.

* Set your television farther away from this unit.

* Try copying at normal speed.