Pioneer GM-A6604 Benutzerhandbuch - Seite 5
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken Pioneer GM-A6604 herunter. Pioneer GM-A6604 19 Seiten. Bridgeable four-channel power amplifier
Auch für Pioneer GM-A6604: Benutzerhandbuch (49 seiten), Benutzerhandbuch (14 seiten)
Setting the unit
What's what
GM-A6604
Front side
Rear side
GM-A4604
Front side
Rear side
To adjust the switch, use a flathead screwdri-
ver if needed.
1 LPF (low-pass filter)/HPF (high-pass fil-
ter) select switch
Switch the settings based on the connected
speaker.
! When the Subwoofer is connected:
Select LPF. This eliminates high range
frequency and outputs low range fre-
quency.
! When the full range speaker is con-
nected:
Select HPF or OFF. HPF eliminates low
range frequency and output high range
frequency. OFF outputs the entire fre-
quency range.
2 GAIN (gain) control
Adjusting gain controls CHANNEL A (chan-
nel A) and CHANNEL B (channel B) helps
align the car stereo output to the Pioneer
amplifier. Default setting is the NORMAL
position.
If output remains low, even when the car
stereo volume is turned up, turn controls to
lower level. If distortion occurs when the car
stereo volume is turned up, turn these con-
trols to higher level.
! If using only one input plug, set the gain
controls for speaker outputs A and B to
the same position.
! For use with an RCA equipped car stereo
(standard output of 500 mV), set to the
NORMAL position. For use with an RCA
equipped Pioneer car stereo, with maxi-
mum output of 4 V or more, adjust level
to match that of the car stereo output.
! For use with an RCA equipped car stereo
with output of 4 V, set to the HIGH posi-
tion.
3 INPUT SELECT (input select) switch
Select 2CH for two-channel input and 4CH
for four channel input.
! You can select input select only for con-
nections when using the RCA input jack.
For connections when using the speaker
input wire, 4CH will be used automati-
cally no matter which switch setting is
selected.
4 FREQ (cut off frequency) control
Cut off frequency selectable from 40 Hz to
500 Hz if the LPF/HPF select switch is set to
LPF or HPF.
! You can select cut off frequency only for
CHANNEL B.
5 BASS BOOST (bass boost level control)
switch
You can select a bass boost level from 0 dB
to 12 dB.
Section
02
5
En