Pioneer GM-DX871 Benutzerhandbuch - Seite 10

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken Pioneer GM-DX871 herunter. Pioneer GM-DX871 16 Seiten. Class d mono amplifier
Auch für Pioneer GM-DX871: Benutzerhandbuch (16 seiten)

Seite drucken
Pioneer GM-DX871 Benutzerhandbuch
(_
c_o
_
n
_ n_ e_
d_i_ng_th
_ e_u_n_
i
t_
s
_____
)
1
Route battery wire from engine com-
partment to the vehicle interior.
•
When drilling a
cable
pass-hole into
the ve-
hicle body and routing a battery wire
thor-
ough
it,
take care
not to
short-circuit
the
wire damaging it by
the
cut edges
or
burrs
of
the hole.
After completing all
other
amplifier connec-
tions, final ly connect
the
battery
wire
term
inal
of the amplifier
to
the
positive
EB
battery term-
inal.
®
I
\
j>---Cr
CD
®
CD
Positive
EB
terminal
@
Battery wire (sold separately)
The maximum
length of
the
wire between
the fuse and
the
positive
EB
terminal
of the
battery is 30cm (12
in.).
@
Fuse 100A (GM-D8701 and GM-DX871)
/
150A (GM-D9701 and GM-DX971) (sold se-
parately)
Each amplifier must be separately fused at
100A (GM-D8701 and GM-DX871)
/ 150A
(GM-D9701 and GM-DX971).
2
Use wire cutters or a utility knife to
strip the end of the battery wire, ground
wire and system remote control wire to ex-
pose about 10 mm (3/8 in.) of the end of
each of the wires, and then twist the ex-
posed ends of the wires.
Twist
---•
I·
1
·I
10mm
(3/8
in.)
3
Connect the wires to the terminal.
Fix the
wires.securely with
the
terminal
screws.
En
CD
Battery
wire
@ Power
terminal
@
Ground
wire
©
GND
terminal
®
System remote
control
wire
®
System remote
control
terminal
(J)
Terminal
screws