Pioneer GM-DX871 Benutzerhandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken Pioneer GM-DX871 herunter. Pioneer GM-DX871 16 Seiten. Class d mono amplifier
Auch für Pioneer GM-DX871: Benutzerhandbuch (16 seiten)

Seite drucken

Connecting the units

Connection diagram

1 Battery wire (sold separately)

The maximum length of the wire be-

tween the fuse and the positive + term-

inal of the battery is 30 cm (12 in.).

For the wire size, refer to Connecting the

power terminal. The battery wire, the

ground wire and the optional direct

ground wire must be same size. After

making all other connections at the am-

plifier, connect the battery wire terminal

of the amplifier to the positive + term-

inal of the battery.

2 Fuse 100 A (GM-D8701 and GM-DX871) / 150 A

(GM-D9701 and GM-DX971) (sold separately)

Each amplifier must be separately fused at

100 A (GM-D8701 and GM-DX871) / 150 A (GM-

D9701 and GM-DX971).

3 Positive + terminal

4 Negative (*) terminal

5 Battery (sold separately)

6 Ground wire, Terminal (sold separately)

The ground wires must be same size as the

battery wire.

Connect to metal body or chassis.

7 Car stereo with RCA output jacks (sold sepa-

rately)

8 External output

9 Connecting wire with RCA pin plugs (sold se-

parately)

a Amplifier with RCA input jacks (sold sepa-

rately)

b Bass boost level remote control

c Bass boost level remote control wire (5 m

(16 ft. 5 in.))

d RCA input jack

e RCA output jack

f System remote control wire (sold separately)

Connect male terminal of this wire to the sys-

tem remote control terminal of the car stereo.

The female terminal can be connected to the

auto-antenna relay control terminal. If the car

stereo lacks a system remote control terminal,

connect the male terminal to the power term-

inal via the ignition switch.

g Speaker output terminals

Please see the following section for speaker

connection instructions. Refer to Connections

when using the speaker input wire.

h Fuse 40 A × 2 (GM-D8701 and GM-DX871) /

40 A × 3 (GM-D9701 and GM-DX971)

i Front side

j Rear side

Before connecting the

amplifier

WARNING

Secure the wiring with cable clamps or adhe-

sive tape. To protect the wiring, wrap sections

in contact with metal parts in adhesive tape.

Never cut the insulation of the power supply

to feed power to other equipment. Current ca-

pacity of the wire is limited.

CAUTION

Never shorten any wires, the protection circuit

may malfunction.