Pioneer M-25 Betriebsanleitung - Seite 5

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Verstärken Pioneer M-25 herunter. Pioneer M-25 10 Seiten. Stereo power amplifier

OPERATION

1. Set the preamplifier's controls as follows:

• Set the preamplifier's power switch to OFF.

• Set the volume control (attenuator) to the

lowest position.

• If your preamplifier has a tape monitor switch,

set it to SOURCE (or OFF). Only when playing

back a tape should it be set to ON.

2. Set the M-25 up as follows:

• Connect the power plug to the power outlet.

If you have connected the power plug to the

spare power outlet (SWITCHED: capacity of

800W or more) on the preamplifier, you will be

able to switch the preamplifier on and off by

operating the power switch on the M-25.

3. Beginning operation

• Set the power switches on the preamplifier and

M-25 to ON.

• Operate the preamplifier, turntable, tape deck or

tuner, and commence play.

• Adjust the volume and tone with the controls on

the preamplifier.

• There will be no sound from the speakers for

between three and eight seconds after the M-25's

power switch has been thrown. This is because

the supply of power actuates the muting circuit

which is designed to eliminate noise when this

switch is thrown. In addition, the protective

circuitry is actuated to safeguard the speakers

from being damaged in the rare case that DC

components enter the output.

• If the sound suddenly stops coming from the

speakers during operation or if you hear the

built-in relays being continuously actuated

('click, click'), this may mean that there is a

speaker connection short-circuit or an overload

(if you are using speakers with an impedance of

less than 4 ohms). In such cases, the protective

circuitry is automatically actuated, and the

transistors and speakers are protected from

any damage. Once the trouble is corrected,

the protective circuitry will be automatically

released, and the M-25 will return to its normal

state of operation.