Pioneer SA-V220 Betriebsanleitung - Seite 3

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Verstärken Pioneer SA-V220 herunter. Pioneer SA-V220 11 Seiten. Stereo mixing amplifier

CONNECTIONS

Connection of Input and Output Cords

¢ Connect white plug to" L " side and red plug to * R " side.

Make sure to insert them securely.

¢ Insert the pin plug of the connecting cords securely.

incomplete

plugging may result in noise or insufficient

sound.

White plug |

;

IF. Red plug

Connection of Speaker Cord

Strip off the vinyl coating and put the wire ends together.

1omm

@ Loosen the screw.

@® Insert the wires into the hole.

@® Tighten the screw and fasten the wires.

Impedance of Speaker System

Speaker systems with a nominal impedance of 4 to 16 Q can

be used when systems A and B are used separately. Use

nominal impedance of 8 to 32 Q when playing both systems

simultaneously.

To use ADAPTOR jacks:

Remove the jumper plug when connecting a graphic equalizer

or sound processor to the ADAPTOR IN/OUT jacks.

Store the jumper plug in a safe place. Do not install it onto

other jacks.

¢ Be sure to install the jumper plug when you are not using the

ADAPTOR jacks.

Output

Pull out the jumper plug.

may cause a malfunction.

NOTES:

¢ When using only the speakers with a separate power amplifier

connected to the SA-V220:

Make sure to set the MASTER VOLUME control of the SA-V220 to '0".

¢ When using speakers with both the SA-V220 and a separate power

amplifier connected to the SA-V220:

Adjust the sound volume of the speaker connected to the SA-V220

using the MASTER VOLUME control of the SA-V220.

¢ Adjust the sound volume of the other speaker connected to the

separate power amplifier using the MASTER VOLUME control of

the power amplifier.