Pioneer CLD-99 Betriebsanleitung - Seite 4

Blättern Sie online oder laden Sie pdf Betriebsanleitung für CD-Spieler Pioneer CLD-99 herunter. Pioneer CLD-99 31 Seiten. Cd cdv ld player

Seite drucken

ACCESSORIES

Video cord

(Pin plug «> Pin plug)

e Remote control unit

e@Size "AAA" (IEC R03)

dry cell battery x 2

to a color monitor, etc.

INSERTING BATTERIES INTO THE REMOTE

CONTROL UNIT

(1) Open the battery compartment cover on the back of the remote

control unit. Press the knob and open the cover in the direction

ofthe arrow.

[2] Take out the two accessory size "AAA" (IEC R03) dry cell

batteries, and insert them into the battery compartment in

accordance with the display (@, ©) inside the compartment.

[3] Close the cover of the battery case.

Incorrect use of batteries may lead to leakage or rupture.

Always be sure to follow these guidelines:

A. Always insert batteries into the battery compartment,

correctly matching the positive @ and negative © polarities,

as indicated inside the compartment.

B. Never mix new and used batteries.

C. Batteries of the same size may have different voltages,

depending on their type. Do not mix different types of

batteries.

Range of remote control operation

When operating the remote control unit, point the unit's infrared

signal transmitter at the remote control unit receiver on the front

panel of the player. The remote control unit can be used within a

range of about 7 meters (23 feet) from the remote sensor, and

within angles of up to about 30 degrees.

When unpacking the player, first check to make sure that all of the accessories listed below are supplied:

Use to connect the player

e Audio cord

(Pin plug x 2 + Pin plug x 2)

Use to connect the player to

a stereo amplifier, etc.

e@S-VIDEO cable

(Mini DIN «+ Mini DIN)

e Operating instructions

eWarranty card

NOTES FOR USING THE REMOTE CONTROL UNIT

e /f a plug is connected to the CONTROL IN terminal at the rear of the

player, remote control operations cannot be done with the remote

control unit aimed at the player's remote control sensor. Aim the

remote control unit at the

AV amplifier or the component display's

sensor instead.

@ if there is any obstacle between the remote control unit and the

player, or if the unit is held at too large an angle relative to the front

panel of the player, the signal from the remote control unit will fail to

reach the remote sensor.

@ /f the player is operating in the vicinity of other appliances generating

infrared rays, or if other remote control devices using infrared rays

are used near the player, the player may operate improperly. Con-

versely, if the player's remote control unit is operated in the vicinity

of other appliances which use an infrared remote control device, the

other appliance may operate improperly. if this should happen,

change the place of installation so that improper operation does not

occur.

e@ if the range of operation of the remote control unit becomestoo short,

replace the batteries.

e@ When the unit is not to be used for a long period of time (more than

one month), remove the batteries to prevent them from leaking inside

the compartment. If leakage occurs, wipe up the liquid inside the

compartment and replace the batteries with new ones.

e Do not place books or other objects on the remote control unit, since

they might depress the buttons and run down the batteries.

e if the remote control sensor windowis in a position where it receives

strong light such as sunlight or fluorescent light, control may not be

possible.