Pioneer CLD-DS04 Betriebsanleitung - Seite 23
Blättern Sie online oder laden Sie pdf Betriebsanleitung für CD-Spieler Pioneer CLD-DS04 herunter. Pioneer CLD-DS04 30 Seiten. Cd cdv ld player
Seite drucken
TROUBLESHOOTING
Incorrect operations
are often mistaken for trouble and malfunctions.
If you think that there is something
wrong with this component,
check
the points below. Sometimes the trouble may lie in another component.
Inspect the other components
and electrical appliances being used. If
the trouble
cannot be rectified
even after exercising
the checks listed below,
ask your nearest PIONEER authorized
service center or your
dealer to carry out repair work,
Common for LD and CD
Operation
Remote
con-
trol
Audio
Symptom
1. The disc table closes and then
re-opens.
2. Remote
control
is not possi-
ble.
3. The TV, etc., functions improp-
erly.
4. Audio is not output or audio is
distorted.
Possible Causes
•
The disc is extremely
dirty.
•
The disc is not placed properly on the disc table.
•
Dew is condensed
inside the player.
•
The CONTROL IN jack on the rear panel is in use.
•
The remote control unit is too far from the player or it is operat-
ed at too great an angle with
respect
to the remote
control
sensor.
•
The batteries are run out.
•
Some TV sets incorporating
the wireless
remote control func-
tion may function
improperly due to the remote control unit of
the player.
•
Connection plugs are inserted insufficiently
or disconnected.
•
Connection plugs or jacks are dirty.
•
The player is in pause mode.
•
The connection
with the stereo amplifier is erroneous.
•
The stereo amplifier
is operated improperly.
(Refer to the ampli-
fier's instruction manual,)
•
The player is connected
to the PHONO input jacks of the stereo
amplifier.
Ref. Page
p. 6
p, 12
p. 4
p. 8
p. ll
p. 5
p. 8
LD
Video, picture
quality
Audio (LD)
Skip, search
Symptom
5, Video is not displayed.
6. Video is not displayed
or the
displayed
video is of a low-
quality or is noisy.
7. A part of the still image
is
shaking.
8. Audio is vibrating.
9. Audio is not heard.
10.Skip, programming
and search
are not possible.
Possible Causes
•
The VHF antenna is not connected
to the modulator.
•
A cable in which the VHF and UHF signals are mixed is con-
nected to the modulator.
•
The TV power is off.
•
The disc is extremely
deformed
(warped, etc.).
•
The connection plug is not fully inserted or is disconnected.
•
Even with the standard disc, a part of the still image may shake
in the case it is a scene containing quick action.
•
A disc without the E_._mark is being played with the CX system
turned on.
•
Audio is not output during multi-speed
playback, still image and
frame advance playback.
•
The disc being played does not contain
the recorded
chapter
numbers.
(The functions
utilizing the chapter numbers
do not
L_
11.Search
takes
a long
time
(,more than 40 seconds).
12.-fhe time taken to start p\a',/-
back is sometimes
long,
13.Other image than specified
is
played back.
work on discs which do not contain chapter numbers.)
•
Some discs need a longer time to read data.
malfunction.)
•
Error in data readout
does occur
sometimes.
(This is not a
malfunction.)
Ref. Page
).9
).6
),8
).17
p. 15
).17
).16
). 20
23
<VRB1147>