Ariston AW122 Broschüre über Pflege, Verwendung und Installation - Seite 17
Blättern Sie online oder laden Sie pdf Broschüre über Pflege, Verwendung und Installation für Waschmaschine Ariston AW122 herunter. Ariston AW122 20 Seiten. Washer / washer-dryer combo
Auch für Ariston AW122: Broschüre über Pflege, Verwendung und Installation (20 seiten), Reparatur-Handbuch (20 seiten), Kurzanleitung (21 seiten)
Seite drucken
Installation Instructions
2. Attach the hose connected to the 'H' valve to the hot
water faucet. Screw on the coupling BY HAND until it is
seated on the gasket. DO NOT OVERTIGHTEN.
3. Attach the hose con-
nected to the 'C' valve
to the cold water faucet.
Screw on the coupling
BY HAND until it is
seated on the gasket.
DO NOT OVERTIGHTEN.
4. Turn on the water
faucets and check for
leaks.
IMPORTANT!
The couplings should be tightened BY HAND,
a tool should only be used if a leak occurs. Do
not use excessive force.
Secure the Drain Hose
1. Drape the power cord over the washer top.
2. Secure the drain hose to the laundry tub leg or
standpipe with a strap or cable-tie.
3. Use the U-Clamp (provided) and insert the drain hose
into the standpipe or sink. DO NOT force excess drain
hose into the standpipe. There should be only 6" of
drain hose in the stand pipe.
U-Clamp
20" (50 cm) min.
with an air break
H
C
6" max.
25" (62 cm) min.
34" (86 cm) max.
Level the Washer-Dryer
After positioning the washer in it's final installation
location, you must level the washer.
The front feet are self
locking and adjustable.
Your machine will be
noisy if the two front feet
are not adjusted so the
machine stands firm and
level.
1. Tilt the machine
back, leaning it
against the wall.
2. Adjust the front feet up or down to ensure the
washer is resting solid and does not rock side-to-
side or front-to back when the machine is upright.
IMPORTANT!
When moving washer to it's final location,
take care not to kink the inlet or drain hoses.
Optional
Splendide SecureFit™
Installation Brackets, Part
No. MK01
• Hook around two front feet
and screw into the floor.
• Designed to keep the washer
from shifting front-to-back or
left-to right.
• Recommended for RV or
Marine Installations.
DID YOU KNOW?
The majority of problems with noisy
machines or excessive vibration are due
to the transit SCREWS/SPACERS NOT
BEING REMOVED or the FEET NOT BEING
ADJUSTED correctly to level the machine.
SecureFit Brackets,
Part No. MKO1
17