Dinan Tronics D440-0052 Installationsanleitung Handbuch - Seite 2
Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Autoteile Dinan Tronics D440-0052 herunter. Dinan Tronics D440-0052 7 Seiten.
Seite drucken During DINANTronics installation, ALL keys must be completely outside this
range. If a key remains within range of the car, the vehicle may respond to the
key and awaken unexpectedly, which could result in a stored fault and check
engine light.
c) Unlock the car and open both the hood and trunk.
d) Close all the doors.
e) Move all keys beyond the range of the car.
f) Leave the vehicle undisturbed for about 10 minutes. This allows adequate time for
the electronics to go to sleep.
g) Disconnect negative terminal of battery.
DINANTronics INSTALLATION:
1. Remove the engine cover by tugging upwards to release the clips, then set cover
aside.
2. The DINANTronics ECU communicates with 3 pressure sensors in the engine
compartment, shown in the layout photo below.
NOTE: There are two possible connector styles for Sensor #3. You may
wish to glance at steps 11& 12, to confirm that the connector on the Dinan
harness is correct for your vehicle, before continuing with this installation.
INS440-0052
#3
#2
Page 2 of 7
DINANTronics
ECU may be
mounted here
#1
Rev 9/18/17