Pioneer S-1EX Betriebsanleitung - Seite 5

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Lautsprechersystem Pioneer S-1EX herunter. Pioneer S-1EX 28 Seiten. Ex series
Auch für Pioneer S-1EX: Broschüre & Specs (16 seiten), Service-Handbuch (12 seiten)

Seite drucken

Connect the matched pairs to the same speaker

terminals on your amp (taking care not to get the

polarity reversed).

Make sure to use the same type of cable for the low-fre-

quency and the same type for the high-frequency connec-

tions.

When bi-amping

Bi-amping is an even more powerful way of connecting your

speakers. Just as with bi-wiring, the input terminal short bars

are removed, but here the low-frequency terminals are

connected to a separate, dedicated low-frequency amp, and

the high-frequency terminals are connected to a dedicated

high-frequency amp.

Tweeter amp

Speaker

R ch L ch

Black Red

Woofer amp

R ch L ch

Attaching and removing the front grille

The front grille of this speaker system is removable. Follow

the instructions below to attach/remove the grilles.

Attaching the grille

Insert the supplied fastening screws into the four

holes provided on the front of the speaker.

Use your fingers (not a screwdriver) to secure the screws to

the front of the speaker.

Fastening

screws

Line up the holes on the grille with the protruding

ends of the screws on the front of the speaker and press

firmly.

Insert the supplied finishing screws into the four

holes on the front of the grille and tighten to secure.

Use your fingers to tighten the finishing screws.

Finishing

screws

Removing the grille

Loosen, then remove the finishing screws from the

four corners on the front of the grille.

After detaching the grille, remove the fastening

screws from the four holes on the front of the speaker.

Speaker

Black Red

Optionally, you can insert the supplied caps into the holes.

• Do not use a screwdriver (or hex wrench) to tighten the

screws. Overtightening could damage the speaker.

• When not in use, store the screws with these operating

instructions for safekeeping.

Magnetic shielding

This speaker system is magnetically shielded. However,

depending on the installation location, color distortion may

occur if the speaker system is installed extremely close to the

screen of a television set.

If this happens, turn off the television, then turn it on again

after 15 min to 30 min. If the problem persists, place the

speaker system away from the television set.

Cleaning the speaker cabinet

With normal use, wiping with a dry cloth should be sufficient

to keep the cabinet clean. If necessary, clean with a cloth

dipped in a neutral cleanser diluted five or six times with

water, and wrung out well. Do not use furniture wax or

cleansers.

Never use thinners, benzine, insecticide sprays or other

chemicals on or near this unit since these will corrode the

surfaces.