Pioneer S-ES21CR-T Betriebsanleitung - Seite 3

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Lautsprechersystem Pioneer S-ES21CR-T herunter. Pioneer S-ES21CR-T 32 Seiten.

Seite drucken

WALL-MOUNTING THE SURROUND

SPEAKERS

Before mounting

• Remember that the speaker system is heavy and that

its weight could cause the screws to work loose, or

the wall material to fail to support it, resulting in the

speaker falling. Make sure that the wall you intend to

mount the speakers on is strong enough to support

them. Do not mount on plywood or soft surface walls.

• Mounting screws are not supplied. Use screws

suitable for the wall material and support the weight

of the speaker.

Mounting screw

(not supplied)

4 mm to 6 mm

• If you are unsure of the quality and strength of the

walls, consult a professional for advice.

• Pioneer is not responsible for any accidents or

damage that result from improper installation.

CABINET MAINTENANCE

Use a polishing cloth or dry cloth to wipe off dust and dirt.

When the cabinet is very dirty, clean with a soft cloth

dipped in some neutral cleanser diluted five or six times

with water, and then wipe again with a dry cloth. Do not

use furniture wax or cleaners.

Never use thinners, benzine, insecticide sprays and other

chemicals on or near the cabinets, since these will

corrode the surfaces.

ATTACHING / DETATCHING THE GRILLE

The front grille of this speaker system is removable.

Proceed as follows:

1. To detatch the grille, grab it by its bottom with both

hands and toward you to separate the bottom part of

the grille from the speaker.

2. Next, grab the top part of the grille and gently pull it

toward you to remove the top portion.

3. To replace the grille, align the holes in the front of the

speaker's corners with the projections on the grille,

and push each of the corners into place.

TROUBLESHOOTING

Symptom Possible cause

No sound

Sound is

distorted.

4 mm

9.5 mm

• Bad speaker cord or

connection.

• Amplifier is off.

• Volume control is at zero.

• Extreme signal condition. • Turn down the

Remedy

• Connect correctly or

replace cord.

• Turn on amplifier.

• Slowly turn up volume.

amplifier's output level

(volume, bass control,

bass boost) to lower the

level.