Pioneer PDP-502MXE Betriebsanleitung - Seite 14

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Monitor Pioneer PDP-502MXE herunter. Pioneer PDP-502MXE 33 Seiten. Pioneer corporation operating instructions plasma display pdp-502mxe

Seite drucken

Installation and Connections

Connection to a personal computer

Connection method differs depending on the computer

type. When connecting, please thoroughly read the

computer's instruction manual.

Before making connections, be sure to make sure that

the personal computer's power and this unit's main

power is off.

For the PC input signals and screen sizes that this unit is

compatible with, please refer to Supplement 1 (page 26).

Connection of separate SYNC analog RGB

source

Make separate SYNC connections for a component that

has RGB output separated into 5 output signals: green,

blue, red, horizontal synchronization signal, and vertical

synchronization signal.

When connecting to INPUT3

(ON SYNC)

INPUT3

(H/V SYNC)

When using INPUT3, set the impedance selector switch

to match the output impedance of the connected

component's synchronization signal.

When the output impedance of the component's

synchronization signal is above 75 , set this switch to

the 2.2 k position.

On-screen setup is necessary after connection.

Please see page 13.

<ARE1350> En

75 j 2.2k

When connecting to INPUT4

ANALOG

OUTPUT

R G B

ANALOG

(

INPUT4

R G B

Connect the cable corresponding to the shape of the

input terminal on this unit and the personal computer's

output terminal.

Secure by tightening the terminal screws on both units.

After connecting, on-screen setup is necessary.

Please see page 13.

Note

Depending on the type of computer model being connected, a

conversion connector or adapter etc. provided with the computer

or sold separately may be necessary.

For details, please read your PC's instruction manual or consult

the maker or nearest dealer of your computer.

When connecting to INPUT4 (OUTPUT)

ANALOG

OUTPUT

R G B

ANALOG

(

INPUT4

R G B

With this unit, it is possible to output the RGB signal to an

external monitor or other component from the INPUT4

OUTPUT terminal.

Note

An RGB signal will not be output from the INPUT4 OUTPUT

terminal when the main power of this unit is off or in standby.

To an external monitor