Pioneer PDP-502MXE Betriebsanleitung - Seite 27

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Monitor Pioneer PDP-502MXE herunter. Pioneer PDP-502MXE 33 Seiten. Pioneer corporation operating instructions plasma display pdp-502mxe

Seite drucken

Operating range of the remote

control unit

When operating the remote control unit, point it at the

remote sensor (Î) located on the front panel of the main

unit. The remote control unit is operable up to 23 feet

(7 m) from the unit and within a 30 angle on each side of

the sensor.

If you are having difficulty with operation of the

remote control unit

¶ The remote control unit may not operate if there are objects

placed between it and the display.

¶ Operational distance will gradually become shorter as the

batteries begin to wear out, replace weak batteries with new

ones as soon as possible.

¶ This unit discharges infrared rays from the screen. Placing a

video deck or other component that is operated by an infrared

remote control unit near this unit may hamper that

component's reception of the remote control's signal, or

prevent it from receiving the signal entirely. Should this occur,

move the component to a position further away from this unit.

¶ Depending on the installation surroundings, this unit's remote

control unit may be influenced by the infrared rays discharged

from the plasma display, hampering reception of its rays or

limiting its operational distance. The strength of infrared rays

discharged from the screen will differ according to the picture

displayed.

Troubleshooting

What may at first seem to be an malfunction, may be

remedied with a quick check.

Please check to see if a warning is displayed on the

screen. If displayed, refer to page 24 and check the

mode. If there is no display check to see if the problem is

listed below. The problem may also be caused by

something other than this unit so please also check the

other components being used such as a video deck. If the

problem can still not be solved please consult the dealer

where this unit was purchased.

General Problems

Problem

• No power

• Unit cannot be operated.

• Remote control does not

operate.

• Picture is cut off.

• Strange color, light color, or

dark, or color misalignment

• Power is suddenly turned

off.

• No picture

• Is the power cord disconnected? (page 12)

• Has the MAIN POWER switch been switched on? (page 7)

• External influences such as lightning, static electricity, etc., may cause improper operation. In this

case, operate the unit after first turning the main power on/off, or unplugging the power cord and

re-plugging it in after 1 to 2 minutes.

• Are batteries inserted with polarity (+, –) correctly aligned? (page 22)

• Are batteries worn out? (Replace with new batteries).

• Is the plug inserted in the CONTROL IN terminal? Because reception of the remote control's

signal will not be possible if the plug is inserted, please check connections (page 11).

• Is the selected screen size correct? Switch to another screen size (page 16).

• Are SCREEN mode adjustments such as picture size made correctly? (page 19).

• Adjust the picture tone (page 18).

• Is the room too bright? The picture may look dark in a room that is too bright.

• The unit's internal temperature has increased. (Air vents are blocked.)

Remove any objects blocking vent or clean (page 22).

• Is the POWER SAVE mode set to "MODE1" or "MODE2"? (page 17)

• Are all connections correct? (page 10)

• Has setup been done correctly after connection? (page 13)

• Is the correct input selected? (page 14)

• Is a non-compatible signal being input? (page 26)

• Is picture adjustment correct? (page 18)

7 m (23 feet)

30˚

Possible Solution

Additional Information

30˚

Remote Sensor

<ARE1350> En