Aeotec Water Sensor 7 Pro Benutzerhandbuch - Seite 7
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Zubehör Aeotec Water Sensor 7 Pro herunter. Aeotec Water Sensor 7 Pro 13 Seiten. Water sensor
Auch für Aeotec Water Sensor 7 Pro: Handbuch (3 seiten), Schnellstart-Handbuch (8 seiten), Benutzerhandbuch (9 seiten), Benutzerhandbuch (14 seiten), Benutzerhandbuch (9 seiten)
Seite drucken
3 QUICK START
3.1
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may
violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting
from failure to comply with the instructions in this manual or any other material. Use this equipment only for its
intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near
open heat sources.
3.2
Optimally placing the product
This is a secure Alarm Sensor. To run this device please insert fresh 1 * 1/2 AA batteries. Please make sure the internal
battery charge is full . The DSK for the S2 inclusion can be found inside the sensors packaging.
If your Z-Wave gateway supports SmartStart: scan the QR code on product using the gateway's app. Your sensor will join
your Z-Wave network automatically.
3.3
How to install the product
The sensor can be mounted on the wall. Mounting can be accomplished either using the tape by peeling off the
protection foil or using two screws with the holes inside the battery compartment.
Water Sensor probe which is hardwired to the Main Unit must be put on the floor or onto any other surface,
where water leakage must be detected.
3.4
How to add the product
The following will step you through adding the product to your Z-Wave network.
1. Open the housing.
2. Remove the battery protection.
3. Press the tamper on the side of the appliance three times quickly.
3.5
How to remove the product
1. Open the housing.
2. Press the tamper on the side of the appliance three times quickly.
3.6
How to manually trigger Wake Up
1. A single click on the button will wake up the device.
2. Repower on will wake up the device.
Note:
The Wake Up period starts when the node issues a Wake Up Notification and it ends either 10 seconds after the last
received/transmitted frame or at the reception of a Wake Up No More Information Command by the Wake Up
destination.
AEOTEC User Manual
Page 4