Ariston NEXT OUTDOOR EVO Benutzerhandbuch - Seite 6
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Warmwasserbereiter Ariston NEXT OUTDOOR EVO herunter. Ariston NEXT OUTDOOR EVO 31 Seiten.
Seite drucken
USER'S MANUAL
Ignition procedure
-
ensure that the inlet cold water valve is open
-
ensure that the gas valve is open
-
ensure that the device is powered by electric current.
When pressing ON/OFF key "2", the display lights.
The device is ready to operate
The set temperature is indicated on the display.
By opening a hot water tap, the device automatically
starts operating.
The display shows the set temperature and the flame
indicates the burner ignition.
WARNING!!
The factory set temperature is 55°C.
TO SET THE WATER TEMPERATURE AT
42°C press the button 3.
Note: If the device does not operate, ensure that the gas
and/or cold water valves are open.
Ensure that the device is electrically powered.
When closing the tap, the device automatically switches
off and the flame symbol disappears from the display.
WARNING!!
Water with a temperature higher than 50°
cause serious burns.
Always verify water temperature before
use.
6
/
Water temperature adjustment
Press keys 3 and 4 to set the hot water temperature.
The new value will be indicated on the display.
It's possible to increase the temperature until 50 °C.
To select temperatures higher than 50°C push simultaneously
the buttons 4 and ON/OFF for few seconds.
The display shows 51 °C and pressing the button 4 again the
increased (in steps of 1°C) up to a maximum
temperature is
of 55 °C.
WARNING!!
TO USE WATER TEMPERATURE >55°C IS
NECESSARY TO CONTACT A QUALIFIED
TECHNICIAN.
Bath Function
The Bath function can be used to
specify an amount of hot water to be
dispensed at a selected temperature.
While the appliance is in standby,
press the Bath button; 10
x10L
and the
symbol appear on the
display.
Use buttons 3 and 4 to set the amount, from 1 (10 litres)
to a 99 (990 litres).
Press the Bath button to save.
The selected temperature appears on the display and can
be adjusted, if necessary, using buttons 3 and 4.
Press the Bath button to save the selected temperature.
On the display flash the the water amount and the selected
temperature.
Open an hot water tap, the Bath function starts the
metering, shown on the display.
During the tapping is possible to adjust the temperature.
The appliance will beep to indicate that the setted litres
has almost been reached:
- 5 litres from the set amount: one beep
- 1 litre from the set amount: intermittent beep.
When the set amount has been reached, the beep stops.
The appliance reset the hot water temperature to the
value setted before the Bath function.
The function can be disabled:
- by pressing the Bath button twice within 3 seconds.
- if the DHW request stops before the set amount is
reached.
- if there aren't DHW request within 3 minutes from the
Bath Function setting.
(100LT)