Ariston STD ProTech 300 Handbuch für Installation und Gebrauch - Seite 13

Blättern Sie online oder laden Sie pdf Handbuch für Installation und Gebrauch für Warmwasserbereiter Ariston STD ProTech 300 herunter. Ariston STD ProTech 300 24 Seiten. Unvented hot water storage cylinders

Seite drucken
www.tradeplumbing.co.uk Call Sales On 08708034288
prevent risk to the appliance's lifespan when disconnecting the protection
system for an extended period of time, it is necessary to drain the appliance
beforehand.
In addition to the 240V network, the electronic circuit is also connected to
the tank, which is to be protected, and to the titanium protection electrode,
INFORMATION FOR THE END USER
Proper operation of the protection system is shown by a continuous green
L.E.D, indicating that the circuits terminals are being supplied with electricity.
In the event of failure, a red L.E.D. indicates that there is a short-circuit
between the electrode and the cylinder tank, that one of the leads (tank or
electrode) is disconnected or that there is no water in the cylinder.
Your appliance is thus properly protected when the green L.E.D. is
illuminated and the red L.E.D. is off. Should this not be the case, please
contact your installer.
FITTING IMMERSION HEATER(S) (100 - 300 litre foor standing only)
These are supplied with but not fitted to 100 - 300 floor-standing models. A
sealing gasket is supplied with each element, however the use of a suitable
sealing compound is recommended to ensure a correct seal. Care must be
taken not to cross thread the immersion heater(s) when fitting. Each
immersion heater is supplied with a regulation thermostat and manual reset
thermal cut-out. This will activate if the regulation thermostat fails. Under no
circumstances should this be by-passed. The immersion heaters supplied
are rated at 3kW, there are 4kW upgrade kits available on request, (the part
number for which is 925392). Should the immersion heater(s) be ugraded to
the 4kW immersion, the electrical circuit and fuse must be checked to
ensure suitability with the higher output. Although the immersion heaters
are a standard 2
1
/
" thread, they must not be substituted with anything but an
4
original Ariston spare part.
N
!
OTE
T
/
HE IMMERSION HEATERS MUST NOT BE FITTED WITHOUT THE THERMOSTAT
THERMAL
-
.
CUT
OUT
DIRECT SYSTEMS
A mains supply of 240V, 3kW (13 amps) is required. Heat resistant cable,
round 3 or 4 core 2.5mm
2
(to BS6141 table 8) must be used to connect the
electrical supply through the Economy 7 time control switch using either
system 'A' or 'B' as illustrated in F
. 2.11.
IG
SYSTEM A
SYSTEM B
F
. 2.11
IG
www.tradeplumbing.co.uk Call Sales On 08708034288
13