Aeotec Nano Shutter Handbuch - Seite 3

Blättern Sie online oder laden Sie pdf Handbuch für Controller Aeotec Nano Shutter herunter. Aeotec Nano Shutter 7 Seiten. Z-wave motor controller

Notes for the wire connection ports:

N – Power input for neutral

L – Power input for live

IN – Input for load power supply

OUT1 – Output for Motor direction 1

OUT2 – Output for Motor direction 2

S1 – External Switch/button 1 control for Motor

S2 – External Switch/button 2 control for Motor

Quick start.

Aeotec Nano Shutter must be paired (included) into a Z-Wave network before it can

receive Z-Wave commands to turn on/off. The Motor Controller can only communicate to

devices in the same Z-Wave network.

Let your Nano Shutter to be connected to the AC power supply. The following

instructions tell you how to link your Nano Shutter to your Z-Wave network. If you are

using other products as your main Z-Wave controller, such as a Z-Wave gateway, please

refer to the part of their respective manual that tells you how add new devices to your

network.

1. Set your Z-Wave controller into pairing mode.

2. Press the Action Button on the Nano Dimmer or toggle the external manual switch once, the

green LED (non-secure indication) will blink to indicate the Nano Dimmer is entering into

pairing mode.

3. If the Nano Dimmer has been successfully added to your Z-Wave network, its RGB LED will

be solid. If the pairing was unsuccessful, the red LED will be on for 2 seconds and then

remain a colourful gradient, repeat the instructions above from step 1.

Page 3