Aeotec NanoMote Quad Benutzerhandbuch - Seite 6
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Hausautomatisierung Aeotec NanoMote Quad herunter. Aeotec NanoMote Quad 9 Seiten.
Auch für Aeotec NanoMote Quad: Betriebshandbuch (10 seiten), Schnellstart-Handbuch (5 seiten), Betriebshandbuch (9 seiten)
Seite drucken
Nano Mote Quad User Guide : Aeotec Group
You'll be able to see a maximum battery use o 3 months o use over green LED indication listed below.
1. Press and hold the NanoMotes button (can be any button) or 20 seconds.
LED will change rom:
Orange //2 seconds
Green //5 seconds
Red //10 seconds
Pink //15 seconds
2. Release the button on the Pink LED status. It will remain Pink or 2 seconds
3. With that 2 second o releasing its button, tap its button again to start the health detection process.
4. The LED will blink pink rapidly, once it inishes the health test, the LED will change to 1 o 3 colors or 2
seconds:
Red = Bad Health
Blue = Moderate Health
Green = Great Health
Note: This unction will only work i paired to a Z-Wave network.
Your NanoMote Quad's battery.
Your NanoMote Quad has a internal rechargeable LIR2450 3.6V battery that will allow you to charge it when it is in low
battery power. The charger's output should be a micro USB terminal with the speci ication o output DC 5V and at least
1A.
The LED color is red during the charging process, and it will turn to green i the charging is inished.
Notes: I the battery health begins to degrade, you can always purchase a new LIR2450 3.6V Battery to replace the
one that comes with this unit.
Removing your NanoMote Quad from a -Wave network.
Your NanoMote can be removed rom your Z-Wave network at any time. You'll need to use your Z-Wave network's
main controller/gateway. To do this, please re er to the part o their respective manuals that tell you how to remove
devices rom your network.
1. Put your primary controller into device removal mode.
2. Take your NanoMote near to your primary controller.
3. Double click the NanoMote button (can be any button), the LED will become a solid green color.
4. I your NanoMote has been removed rom your Z-Wave network, its LED will begin cycling through rainbow colors.
Manually factory reset NanoMote.
I you ind that your gateway is no longer unctioning and you need to pair your NanoMote to a new Z-Wave gateway,
per orm the steps below to manually actory reset your NanoMote. We recommend that you per orm the Removal
process instead i your gateway that NanoMote is connected to is still unctioning.
To manually actory reset, ollow these steps:
6 z 9
ttps://aeotec.fres desk.com/support/solutions/articles/6000184696-n...
9. 9. 2019, 15:53