Ariston 7OF 627 C RU/HA Betriebsanleitung - Seite 10
Blättern Sie online oder laden Sie pdf Betriebsanleitung für Backofen Ariston 7OF 627 C RU/HA herunter. Ariston 7OF 627 C RU/HA 20 Seiten.
Seite drucken
Maintenance and care
Switching the appliance off
GB
Disconnect your appliance from the electricity supply
before carrying out any work on it.
Cleaning the appliance
• The stainless-steel or enamel-coated external parts as
well as the rubber seals may be cleaned using a
sponge that has been soaked in lukewarm water and
neutral soap. If these stains are difficult to remove,
use only specialised products. After cleaning, rinse
and dry thoroughly. Do not use abrasive powders or
corrosive substances.
• Ideally, the inside of the oven should be cleaned after
each use, when it is still lukewarm. Use hot water and
detergent, rinse and dry with a soft cloth. Do not use
abrasive products.
• All accessories can be washed like everyday
crockery, and are even dishwasher safe.
• Never use steam cleaners or pressure cleaners on the
appliance.
Cleaning the oven door
Clean the glass part of the oven door using a sponge
and a non-abrasive cleaning product, then dry
thoroughly with a soft cloth. Do not use rough abrasive
material or sharp metal scrapers as these could scratch
the surface and cause the glass to crack. To clean more
thoroughly, you can remove the oven door.
1. Open the oven door fully ( see diagram ).
2. Lift up and turn the small levers located on the two
hinges ( see diagram ).
Inspecting the seals
Check the door seals around the oven periodically. If
the seals are damaged, please contact your nearest
After-sales Service Centre ( see Assistance ). We
recommend not using the oven until the seals have
been replaced.
10
F
3. Grip the door on the two
external sides and close it
approximately half way. Unlock
the door by pressing on the
clamps F F F F F , then pull the door
towards you lifting it out of its
seat ( see diagram ).
To replace the door, reverse this
sequence.
Replacing the light bulb
To replace the oven light bulb:
1. Remove the glass cover of the lamp-holder.
2. Remove the
light bulb and
replace it with a
similar one:
Wattage 25 W, cap
E 14.
3. Replace the
glass cover ( see
diagram ).