Aeotec MULTISENSOR 6 Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Sicherheitssensoren Aeotec MULTISENSOR 6 herunter. Aeotec MULTISENSOR 6 8 Seiten. Z-wave water and flood sensor
Auch für Aeotec MULTISENSOR 6: Benutzerhandbuch (13 seiten), Handbuch (3 seiten), Handbuch (10 seiten), Benutzerhandbuch (13 seiten)

Seite drucken
Aeotec MULTISENSOR 6 Benutzerhandbuch
11/21/2017
1. Press and hold Water Sensor 6 Action button
2. Wait until the RGB LED turns into a Purple Color
3. Release Water Sensor 6 Action Button
The RGB LED will blink its Purple color while sending ping messages to your gateway, when it has finished, it will blink 1 of
3 colors:
Red = Bad Health
Yellow = Moderate Health
Green = Great Health
Be sure to watch for the blink, as it will only blink once very quickly.
Manual factory reset Water Sensor 6.
We highly suggest using the gateway to remove your Water Sensor 6 from the network, but in the case that you no longer
have a controller on hand and you'd like to reset your Water Sensor 6 in preparation for a new controller, follow the steps
below:
1. Press and hold the Action Button of your Water Sensor 6 for 20 seconds.
2. Wait until the RGB LED turns into a green or rainbow gradient Color after 20 seconds of holding.
3. Release the Action Button.
4. If your Water Sensor 6 has been successfully factory reset, the RGB LED will be active with a colorful gradient for 3
seconds before disappearing. When you tap the Action Button on Water Sensor, its green LED will blink rapidly. If
the factory reset was unsuccessful, the green LED will remain on solid for a few seconds when you tap the Action
Button.
Replacing your sensors battery.
Your Water Sensor 6 uses 1x CR123A battery that has a 2 year battery life maximum. Ultimately the battery life of the
sensor will highly depend on the uses and settings of Water Sensor. When battery power has depleted, below are the steps
you can take to replace the battery in your Water Sensor 6.
1. Unscrew the 2 screws from Water Sensor 6. On the rear of Water Sensor 6 you'll find 2 screws in opposing corners.
https://aeotec.freshdesk.com/support/solutions/articles/6000171886-water-sensor-6-user-guide-
Water Sensor 6 user guide. : Aeotec by Aeon Labs
6/8