Whirlpool 1CWTW4840YW1 Installationsanleitung Handbuch - Seite 2

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Waschmaschine Whirlpool 1CWTW4840YW1 herunter. Whirlpool 1CWTW4840YW1 16 Seiten.
Auch für Whirlpool 1CWTW4840YW1: Handbuch für Gebrauch und Pflege (28 seiten)

Seite drucken

INSTALLATION

REQU[REMENW$

Tools and Parts

Gather required tools and parts before starting installation.

Tools

needed:

Adjustable or open end

wrench 9/16"(14 mm)

Level

4 =.n3in

(102 mm}_

Wood block

Ruler or measuring tape

Alternate

parts:

(Not supplied with washer)

Your installation may require additional parts. To order, please

contact the dealer from whom you purchased your washer or an

authorized service company.

If you have:

Overhead sewer

1" (25 mm) standpipe

You will need:

Standard 20 gal. (76 L) 39" (990 mm)

tall drain tub or utility sink, sump

pump and connectors

(available from

local plumbing suppliers)

2" (51 mm) diameter to 1" (25 mm)

diameter Standpipe Adapter

Part Number 3363920

Connector Kit Part Number 285835

Drain hose too short

Extension Drain Hose Part

Number 285863

Connector Kit Part Number 285835

Lint clogged drain

Drain Protector Part Number 367031

Connector Kit Part Number 285835

LOCATION

REQU[REMENWS

Select proper location for your washer to improve performance

and minimize noise and possible "washer walk". Install your

washer in a basement, laundry room, closet, or recessed area.

Pliers that open to 1%6"

(39.5 mm)

Optional

tools:

]

42"

(1067 mm)

Flashlight

Bucket

Parts supplied:

NOTE: All parts supplied for installation are in

cardboard insert in the top of the washer.

Drain hose with clamp,

U-form, and cable tie

"Y" connector

You will need:

[] A water heater set to 120 ° F (49° C).

[] A grounded electrical outlet located within 4 ft (1.2 m) of

power cord on back of washer.

[] Hot and cold water faucets located within 3 ft (0.9 m) of hot

and cold water fill valves on washer, and water pressure

of 5-116 psi (35-800 kPa).

[] A level floor with maximum slope of 1" (25 mm) under entire

washer. Installing on carpet is not recommended.

[] Floor must support washer's total weight (with water and load)

of 315 Ibs (143 kgs).

IMPORTANT:

Do not install, store, or operate washer where it will

be exposed to weather or in temperatures

below 32 ° F (0° C).

Water remaining in washer after use may cause damage in low

temperatures.

See "Washer Care" in your Use and Care Guide

for winterizing information.

Proper installation is your responsibility.

Net hoses

Rubber washer