Whirlpool 3LWTW4840 Installationsanleitung Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Waschmaschine Whirlpool 3LWTW4840 herunter. Whirlpool 3LWTW4840 44 Seiten.

Remove packing tray from tub

Remove tape from washer lid, open lid and remove cardboard

packing tray from tub. Be sure to remove all parts from tray.

NOTE: Keep tray in case you need to move washer later.

Free power cord

Firmly grasp power cord plug and pull to free from rear panel.

Gently place power cord over console to allow free access

to back of washer.

CONNECT DRAIN HOSE

Attach drain hose to drain port

Remove the red plastic plug from the black drain port on the

back of the washer.

If clamp is not already in place on elbow end of drain hose, slide

it over end as shown. Squeeze clamp with pliers and slide black

elbow end of drain hose onto black drain port and secure with

clamp.

For a laundry tub or standpipe drain, go to step 6.

For a floor drain, remove the preinstalled drain hose form as

shown in Step 7. You may need additional parts with separate

directions. See "Tools and Parts".

Place drain hose in standpipe

Drain

hose form

114 mm

(4.5")

Place hose into standpipe (shown in picture) or over side of

laundry tub.

IMPORTANT: 114 mm (4.5") of drain hose should be inside

standpipe; do not force excess hose into standpipe or lay

on bottom of laundry tub. Drain hose form must be used.

Remove drain hose form (floor drain

installations only)

For floor drain installations, you will need to remove the drain

hose form from the end of the drain hose. You may need

additional parts with separate directions. See "Tools and Parts".