Whirlpool 3MAS4132FW1 Handbuch für Gebrauch und Pflege - Seite 13
Blättern Sie online oder laden Sie pdf Handbuch für Gebrauch und Pflege für Waschmaschine Whirlpool 3MAS4132FW1 herunter. Whirlpool 3MAS4132FW1 16 Seiten.
Seite drucken
C
OMMON WASHING PROBLEMS
Problem...
Washer makes noise
(cont.)
Won't fill/rinse/agitate
or wrong
temperature
Washer stops
Agitator operation
Water level seems
too low or washer
not completely filling
Washer tub is
crooked
( CONT
Cause...
•
Gears engaging after drain and
before spin.
•
Upper part of agitator clicks
during wash.
•
Power cord not plugged in.
•
Cycle Control knob is not lined up.
•
Water inlet valve screens are
plugged.
•
Water is turned off.
•
Hot and cold hoses are reversed.
•
Inlet hose is kinked.
•
Power cord not plugged in.
•
No power at plug.
•
Fuse blown or circuit breaker open.
•
Using an extension cord.
•
Cycle Control knob is not lined up.
•
Cycle Control knob not pulled out.
•
Washer at pause in Permanent
Press cycle (approximately
2 minutes).
•
Machine is overloaded.
•
The top of the agitator moves only in
one direction.
•
The top of the agitator is loose.
•
The top of the agitator is much high-
er than the highest water level. This
creates a perception of the washer
not being full.
•
Tub is pulled forward when
unloading.
•
Tub moves.
•
Unit not level.
.
)
Solution...
•
This is normal.
•
This is normal.
•
Plug in power cord.
•
Turn Cycle Control knob to the
right slightly and pull to start.
•
Clean screens.
•
Turn on water.
•
Reverse hoses.
•
Straighten hoses.
•
Plug in power cord.
•
Check electrical source or call
electrician.
•
Replace fuse or reset circuit breaker.
If problem continues, call electrician.
•
Do not use extension cords.
•
Turn Cycle Control knob to the right
slightly and pull to start.
•
Set and pull out knob.
•
Allow cycle to continue.
•
Wash smaller loads.
•
This is normal.
•
This is normal.
•
This is normal.
•
Push tub to centre before starting.
•
This is normal.
•
Ensure front feet are installed and
nuts tightened. Level washer. Reset
rear leveling legs. See Installation
Instructions.
TROUBLESHOOTING
continued on next page
13