Whirlpool 7MWFC5090KC Gebrauchs- und Pflegeanleitung und Installationshinweise - Seite 24
Blättern Sie online oder laden Sie pdf Gebrauchs- und Pflegeanleitung und Installationshinweise für Waschmaschine Whirlpool 7MWFC5090KC herunter. Whirlpool 7MWFC5090KC 40 Seiten. Smart all-in-one washer and dryer
Seite drucken
Route Drain Hose
Proper routing of the drain hose protects your floor from damage
due to water leakage. Read and follow these instructions.
1.
Remove drain hose from washer/dryer
Gently pull the corrugated drain hose from the shipping clips.
2.
Connect laundry tub drain or
standpipe drain hose form (floor
standpipe, wall standpipe, or laun-
dry tub drain installations only)
For floor standpipe, wall standpipe, or laundry tub drain
installations, you will need to connect the drain hose form to
the end of the drain hose. You may need additional parts with
separate directions. See "Assistance or Service."
24
3.
Place drain hose in standpipe
Drain
hose form
Place hose into standpipe (shown in picture) or over side of
laundry tub.
IMPORTANT: Only 41⁄2" (114 mm) of drain hose should be
inside standpipe; do not force excess hose into standpipe or lay
on bottom of laundry tub. Drain hose form must be used.
Connect Inlet Hose
Washer/dryer must be connected to the cold water faucet with a
new inlet hose with a flat washer. Do not use the old hose.
NOTE: Hose must be attached and have water flowing to inlet
valve.
1.
Connect inlet hose to water faucet
Cold Water
Attach hose to cold water faucet. Screw on coupling by hand
until it is seated on washer. Use pliers to tighten couplings an
additional two-thirds turn.
IMPORTANT: Do not overtighten or use tape or sealants on
valve when attaching to faucet or washer/dryer. Damage can
result.