Whirlpool 8316566 Installationsanleitung Handbuch - Seite 5

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Waschmaschine Whirlpool 8316566 herunter. Whirlpool 8316566 8 Seiten.

4. Pull yellow shipping strap firmly, until both ends are

completely removed from washer.

5. Check that the two (2) cotter pins were removed with the

shipping strap.

Connect Drain Hose

Proper connection of the drain hose protects your floors from

damage due to water leakage. Read and follow these instructions.

The drain hose is connected to your washer and is stored inside

the washer cabinet.

Remove drain hose from washer cabinet

Gently pull the corrugated drain hose out of the washer from the

top of the hose. Continue to pull the hose until the end emerges.

Do not force excess drain hose back into the rear of the washer.

Laundry tub drain or standpipe drain

Connecting the drain hose form to the corrugated

drain hose

A. Place end of drain hose form around hose at drain hose relief.

Squeeze the latch of the drain hose form until it snaps into place.

B. Place the other end of the drain hose form around one of the

remaining drain hose reliefs. Squeeze the latch of the drain hose

form until it snaps into place.

C. Drain hose relief

To keep drain water from going back into the washer:

Do not force excess drain hose into standpipe. Hose should

be secure but loose enough to provide a gap for air.

Do not lay excess hose on the bottom of the laundry tub.

Floor drain

Do not install the drain hose form on to the corrugated drain hose.

You may need additional parts. See Floor drain under "Tools and

Parts."

1. Insert one new large flat washer into one end of each inlet

hose. Firmly seat the washers in the couplings.

2. Screw on the hose adapter by hand until it is seated on the

washer. Using pliers, tighten the hose adapter with an

additional two-thirds turn.

A. Inlet hose coupling

B. Large flat washer

NOTE: Do not overtighten.

3. Insert one new small flat washer into the end of the hose

adapter. Firmly seat the washers in the couplings.

C. Hose adapter

D. Small flat washer